Sealer Sales KS-FS455, KS-FS605 User Manual

Automatic Foot Sealers
Model: KS-FS455, KS-FS605, KS-FS805

Distributed By:

Version 1.1
Last Updated: 2/20/2020

Sealer Sales | www.sealersales.com | Tel: [phone] | E-mail: [e-mail]

General Information

KS- FS E Q U I P M E N T I N F O R M A T I O N

 Model #

 Serial #

 Purchase Date:

 Reference # (found on packing slip)

 Owner:

Thank you for purchasing our KS-FS Automatic Foot Sealers

This owner’s manual contains information relating to your foot sealer. The manual will provide you
with basic information concerning both operation and maintenance of your new machine. Please read
it carefully as failure to do so may result in bodily injury and/or damage to the equipment.

Please fill in the information below. You will find the information on the machine identification plate.
You will need this information when ordering replacement parts or making technical inquiries.

No part of this manual may be duplicated, reproduced, stored in a retrieval system, translated, transcribed, or
transmitted in any form without the express prior written permission of Sealer Sales.

ii

iii

Table of Contents

Safety Instructions ........................................................................................... 1

Introduction ...................................................................................................... 3

Operating your Foot Sealer ............................................................................ 5

Maintenance ...................................................................................................... 7

Parts Diagram ................................................................................................. 10

Troubleshooting ............................................................................................. 13

Spare Parts List ............................................................................................... 14

KS- F S I N S T R U C T I O N M A N U A L

Safety Instructions

WARNING!

Below are general safety precautions and warnings that should be

understood prior to setting up or operating your equipment. Read and fully understand all instructions and
warnings prior to using this unit. Your safety is most important! Failure to comply with procedures may
result in serious injury or property damage. Remember:

responsibility.

Unsafe practices or unauthorized modifications could result in accidents or property damage. Failure to follow these
safety rules and take necessary precautions can result in serious injury as well as damage to equipment.

 Never operate or service your sealer until you have read this manual completely and understand it fully.
 Plug the sealer into a standard 120 Volt, 60Hz wall outlet or surge protector.
 Do not use the sealer if the power cord, plug or any other parts are damaged. Be sure not to allow the

power cord to drape into your work area. Check that all parts are operating properly and perform the
intended functions. Check for any worn parts before starting operation. Check for all other conditions that
may affect the operation.

 Reduce risk of unintentional starting. Make sure the power switch is in the "OFF" position before attaching

to the power source.

 Always disconnect sealer from power source before servicing, changing accessories or cleaning the unit.
 To provide protection against the risk of electrical shock, the power connection must be properly grounded

at all times.

Your personal safety is your

 Do not leave the sealer unattended when in use. Disconnect the sealer from the power source before

leaving the work area.

 Sealer is used solely for sealing thermoplastic materials. Using the machine for any other purpose can cause

damage to the machine and operator. Do NOT use the machine for any other purpose other than to seal
thermoplastic materials. Doing so may result in damage to the machine and injury to the operator.

 While operating machinery, wear close-fitting clothing and tie back long hair to prevent any external items

from getting caught in the machine. Do not wear jewelry when operating the sealer.



Never touch the heating elements with bare hand while the sealer is plugged into a power source, in
operation or just finished operation. Touching heated areas may cause fire and/or severe burns.

1