Schneider Electric SMT2200, SMT3000 User Manual

Installation Guide SMT2200 and SMT3000 Optional Replacement PDU

Important Safety Messages

Read the instructions carefully. Become familiar with the device before trying to install, operate, service or
maintain it. The following special messages may appear throughout this document or on the equipment to warn
of potential hazards or to call attention to information that clarifies or simplifies a procedure.

The addition of this symbol to a Danger or Warning product safety label indicates that an
electrical hazard exists that will result in personal injury if the instructions are not followed.

The addition of this symbol to a Warning or Caution product safety label indicates that a hazard
exist that can result in injury and product damage if the instructions are not followed.

DANGER

DANGER indicates a hazardous situation which, if not avoided, will result in death or serious
injury.

WARNING

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious
injury.

CAUTION

CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate
injury.

NOTICE

NOTICE is used to address practices not related to physical injury.

Product Handling Guidelines

<18 kg
<40 lb

Hardwire safety

• Check that all branch circuit (mains) and low voltage (control) circuits are deenergized, and locked out
before installing cables or making connections, whether in the junction box or to the UPS.

• Wiring by a qualified electrician is required.

• Check national and local codes before wiring.

• Strain relief is required for all hardwiring (supplied with select products). Snap in type strain reliefs are
recommended.

• All openings that allow access to UPS hardwire terminals must be covered. Failure to do so may result in
personal injury or equipment damage.

• Select wire size and connectors according to national and local codes.

18-32 kg
40-70 lb

32-55 kg
70-120 lb

>55 kg
>120 lb

Installation

A

WARNING

RISK OF ELECTRIC SHOCK

• Adhere to all national and local electrical codes. A certified electrician must perform all electrical connections.

• Diconnect equipment connected to the UPS.

• Press the OFF button located in front of the UPS.

• Disconnect the batteries in the UPS.

• Disconnect UPS from the AC utility power.

Failure to follow this instruction can result in death, serious injury, or equipment damage.

Note: The illustrations in this manual may differ slightly in appearance from the actual hardware.

Remove the five screws that secure the factory
installed PDU panel to the UPS. Save the screws.

Disconnect the PDU output cables as shown in the
diagrams.

Do not disconnect the AC input connector.

Locate and snap together the corresponding
connectors on the UPS and the replacement PDU
panel.

Note: The two pin connector will not be utilized
with the replacement PDU panel.

Secure the replacement PDU panel to the UPS with
the screws removed from the factory installed PDU
panel.

su06695a

C Input Connector

SUA027 SUA029

su06693a

su06694 a

SMT2200 and SMT3000 Optional Replacement PDU2