Schneider Electric Smart-UPS Installation Guide

™

Installation Guide Smart-UPS

X

2000/2200/3000 VA Tower/Rack-Mount 4U

Important Safety Messages

Read the instructions carefully to become familiar with the equipment before trying to install, operate,
service or maintain it. The following special messages may appear throughout this manual or on the
equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a
procedure.

The addition of this symbol to a Caution product safety label indicates that a hazard exists that can result in
injury and product damage if the instructions are not followed.

The following safety messages may appear throughout this manual to warn of potential hazards.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or

moderate injury.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.

Safety and General Information

Read the Safety Guide supplied with this unit before installing the UPS.

• Adhere to all local and national electrical codes.

• This UPS is intended for indoor use only.

• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or
humidity.

• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.

• The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated
ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten
battery life.

• Connect the UPS power cable directly to a wall outlet. Do not use surge pro tec to rs or extension cords.

• The batteries are heav y. Remove the batteries pr ior to installing the UPS in a rack.

• Always install external battery packs (XLBPs) at the bottom of the rack. The UPS must be installed
above the XLBPs.

• The UPS display interface will re cog niz e as many as 10 external battery packs conn ected to the UPS.
However there is no limit to the number of XLBPs that can be used with the UPS.

• Refer to Specifications in the Operation manual for UPS and battery weight.

Inventory

Inspect the contents upon receipt. Notify the carrier and dealer if the unit is damaged.

Included with all models

1 pair tower stabilizer brackets
Use 8 flat head screws to secure tower stabilizer brackets to the UPS
1 pair rack-mount brackets
Use 8 flat head screws to secure rack-mount brackets to the UPS
Use 4 ornamental screws to secure rack-mount brackets to the rails
Install a cage nut in the rack to secure the top hole of each rack-mount bracket in a four post rack

Included with models that have factory installed

Network Management Cards

Rail kit

1 pair support brackets Two post racks

10 screws

Included with High Voltage (HV) models

Included with model SMX3000HVT

Four post rack s
6 screws
6 washers

1 pair rail cleats
8 pan head screws

Smart-UPS X 2000/2200/3000 VA Tower/Rack-Mount 4U2

Product Overview

su0343a

Electric

su0756a

GROUP 1GROUP 2

su0757a

Front panel features

 Online LED
 Power
 On Battery LED
 Site Wiring Fault LED
 Replace Battery LED
 LCD display screen

APC By Schneider





Rear panel features

 SmartSlot  Controll able Outlet G roup 3
 Chassis ground screw  External battery pack connector
 UPS utility power input  EPO connector
 Circuit Breaker reset  Serial port
 Controllable Outlet Group 1  USB port
 Controllable Outlet Group 2

ON/OFF button

UP/DOWN arrow keys
ENTER key
ESC key

2000 VA, 120 Vac Low Voltage 3000 VA, 120 Vac Low Voltage

GROUP 3

Smart-UPS X 2000/2200/3000 VA Tower/Rack-Mount 4U 3