Schlage WCE100, WCW100 User Manual
Camera User Guide
POWER
NETWORK
POWER
NETWORK
Plastic
Nut
Plastic
Washer
Threaded
Post
WCW100 Wireless Camera
There are two cameras available for use with the Schlage
LiNK system.
WCW100
The WCW100 is a wireless camera that communicates
with the Schlage LiNK system through your existing
wireless router.
WCE100
The WCE100 is a wired camera that communicates with
the Schlage LiNK system through your existing router.
DO NOT connect Ethernet or power before
enrolling the camera.
!
For indoor use ONLY!
WCE100 Wired Camera
Wireless Antenna (WCW100 Only)
Rotate the wireless antenna onto the threaded post to ensure clear wireless
communication. Antenna can be adjusted to obtain a better signal. Best results
are usually obtained by positioning the antenna vertically.
Camera Stand
Install the camera stand to provide a steady base for the camera.
1. Loosen the plastic nut on the back of the camera.
2. Rotate the threaded post upwards.
3. Rotate the camera onto the threaded post until it stops.
4. Tighten plastic washer against camera to secure.
Attaching the Antenna
Attaching the Camera to the Stand
POWER
NETWORK
Privacy
Button
NETWORK
POWER
Do Not
Use
Power, Ethernet and MAC ID
WPS
POWER
LAN
Speaker
OUT
5V/1A
IC ID: 7954A
WCW100
XXXXXXXXXX
XXXXXXXXXX
Do Not
Use
IC ID: 7954A
WCW100
XXXXXXXXXX
XXXXXXXXXX
WPS
POWER
LAN
Speaker
OUT
5V/1A
DO NOT connect power and Ethernet until instructed to do so by the web
site, during the enrollment process.
MAC ID is located on the label on the back of the camera.
Privacy Button
The privacy button can be used to temporarily suspend video transmission.
Enable Privacy
Press the privacy button. Button will light green when activated.
Disable Privacy
Press the privacy button. Green light will go out when video transmission
resumes.
Power and Ethernet
WPS Button
DO NOT use the WPS button. Pushing this button may prevent the camera from
enrolling to the LiNK system properly.
If the button is accidentally pushed, power must be disconnected and then
reconnected to the camera before enrolling the camera.
Reset Button
Î Using the reset button is not recommended.
To change camera setup, follow the steps under Moving the Camera to a
Different Account.
Î Pressing the reset button will restore factory default camera settings.
In most cases, this WILL NOT correct issues with connecting or
viewing the camera.
1. Connect power to camera.
2. Using a small pin, press and hold the reset button for 15 seconds. Then
release the button.
3. LEDs will turn off and then on.
Privacy Button
WPS Button
Reset Button
Loading...