Page 1
Removing the propeller shaft
Note:
Tools
Examples of suitable tools from Scania:
Part number Designation
99 222 Propeller shaft tool
99 224 Lifting tool, propeller
shaft
Work description
Never prise between the contact surfaces.
Use tool 99 222 (or tool with corresponding function) if it is difficult to contract the
propeller shaft.
Tools
03:13-00 Issue 1 en-GB 1 (3)
©
Scania CV AB 2012, Sweden
Page 2
Removing the propeller shaft
205 755
Instead of prising the bearing retainers out, you can screw in 4 M16 screws into both
bearing retainers. Tighten the screws alternately (max. 60 Nm) against the end yoke
until the two bearing retainers are loose.
Work description
03:13-00 Issue 1 en-GB 2 (3)
©
Scania CV AB 2012, Sweden
Page 3
Removing the propeller shaft
99 224
205 419
205 756
99 222
(P300-
P500)
1. Secure the propeller shaft with a jack and propeller shaft tool 99 224, or tool with
corresponding function.
2. Remove the screws securing the propeller shaft to the end yoke.
Work description
03:13-00 Issue 1 en-GB 3 (3)
3. Prise the bearing retainers alternately off both sides, if there is enough room.
4. Lower the propeller shaft slightly so that it comes free from the gearbox driver.
5. Remove the screws securing the propeller shaft at the other end.
6. Lower the propeller shaft and roll it out of the vehicle.
©
Scania CV AB 2012, Sweden
Loading...