Scania Removing the left-h, cylinder head bank Service Manual

Removing the left-hand cylinder head bank

WARNING!

212 754

Remove the parts marked in grey

General

Applies to engines with cylinder block generation 2.

The fuel system has a very high fuel pressure of up to 3,000 bar. The fuel system must be depressurised using SDP3 before any work is started.

The system should always be treated as pressurised, even when the engine is switched off.

Wear protective gloves and goggles.

Examples of suitable tools from Scania:

Part number Designation

99 614 Lifting tool

588 955 Socket

General

• Wash the engine

• Drain the coolant

• Evacuate the pneumatic system

Remove the parts in the following order:

1. Turbocharger

03:37-00 Issue 1 en-GB 1 (5)

Scania CV AB 2012, Sweden

Removing the left-hand cylinder head bank

330 528

2. Belt transmission

3. Oil mist separator

4. Alternator

5. AC compressor

6. Inlet pipe to compressor

7. Cooling coil for compressor

8. Connecting pipe between the intake manifolds

Remove the parts in the following order:

1. Test connection for fuel pressure

2. High pressure pipe between right-hand and left-hand accumulators

3. Fuel pipe between the fuel manifold and the fuel filter

4. High pressure pipe between high pressure pump and left-hand accumulator

5. Connection pipe between right-hand and left-hand fuel manifolds

Work description

03:37-00 Issue 1 en-GB 2 (5)

Scania CV AB 2012, Sweden

+ 3 hidden pages