SARGENT 1540 User Manual

1546, 1547, 1548, 1549 SERIES
SURFACE OVERHEAD HOLDERS & STOPS
INSTALLATION INSTRUCTIONS

NON-HANDED. LEFT HAND SHOWN, RIGHT HAND OPPOSITE.

FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com

1

• Use the attached template that corresponds with the type of hinge being used

• Drill door for channel and drill and tap metal frame for #12-24

machine screws to attach jamb bracket

• Secure channel to door (spring end towards hinge) with machine screws and

2

mortise nuts provided

• For models 1547, 1548 and 1549 only, install bracket on channel as shown

• Secure jamb bracket to frame with fasteners provided

SPRING

END

JAMB BRACKET

LEFT HAND SHOWN

BRACKET

Holding tension adjustment on hold open models only

3

(1546H, 1547H, 1548H and 1549H)

• To increase tension insert a 9/32"

allen wrench and turn clockwise as required

Friction adjustment on models

4

1546F, 1547F, 1548F and 1549F only

• To increase friction, insert flat bladed screw driver as shown

and turn clockwise for desired friction

Copyright©SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without theexpress written
permission of SARGENT Manufacturing is prohibited.

A7501B

14

A7501B TEMPLATE 7489D TEMPLATE 7490C A7501B