SARGENT 1530 User Manual

1536, 1537, 1538, 1539 SERIES

CONCEALED OVERHEAD HOLDERS & STOPS

INSTALLATION INSTRUCTIONS

ON-HANDED. LEFT HAND SHOWN, RIGHT HAND OPPOSITE.

N

FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com

• Use the attached template that corresponds with the type of hinge being used

1

• Drill and tap prepared metal door for channel and frame for jamb bracket. Fasten with
#12-24 machine screws provided

2

• Install channel into door (spring end towards hinge)

• Secure channel with fasteners provided

• Secure jamb bracket to frame with fasteners provided

Channel

Hinge

Spring end

3

Holding tension adjustment on hold open models only

LEFT HAND SHOWN

(1536H, 1537H, 1538H and 1539H)

• To increase tension insert a 3/32” Allen wrench.

Turn clockwise as shown.

Jamb bracket

4

Friction adjustment on models
(1536F, 1537F, 1538F and 1539F) only

• To increase friction, insert flat bladed screw driver as shown

and turn clockwise until desired friction is attained

Copyright©SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.

A7500D

1

2

A7500D TEMPLATE 7485D