SARGENT 1000 P2 User Manual
Auxiliary Power Cable Instructions
For Hard Powering Passport 1000
P2 Installations (91- Option)
SECTION I: OVERVIEW
1. Description (Fig. 1).
The auxiliary power cable (P/N 52-4029) is intended for use in Passport 1000 P2 installations when AA batteries
are not used as the primary power source. It is intended only for use when connecting through an ElectroLynx™
harness to Sargent 3267 power supplies.
Auxiliary Power Cable
(P/N 52-4029)
Power Connector
Ground Wire Lug
Ferrite
Fig. 1
SECTION II: INSTALLATION PROCEDURE
1. Route ElectroLynx cable through the door.
Install cable while installing the door harness and lock assembly.
Note: This step is only necessary when not using a pre-wired door.
2. Connect auxiliary power cable to 8-pin ElectroLynx cable (Fig. 2).
Notes:
Connectors go on only one way.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
3. Route connector and ground wire (Fig 3).
Keep ferrite behind the fire plate and bring power
connector and ground wire to the front.
ElectroLynx Connector
2
1
ElectroLynx
Connector
Inside of Door
Fig. 2
4. Fasten ground wire and motor ground wire (Fig. 3).
• Fasten ground wire along with motor ground wire
using lower right escutcheon screw.
5. Connect Hirose connector to circuit board (Fig. 4).
• Plug power connector to back of circuit board.
• Snap housing into place.
Mounting Plate
3
Power
Connector
4
Fig. 3
FOR INSTALLATION ASSISTANCE CONTACT SARGENT • 1-800-810-WIRE (9473) • www.sargentlock.com
Ground
Wire Lug
5
Power
Connector
Fig. 4
Outside of Door
A8039A 1
Copyright © 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
05/30/10
Loading...