3.5 mm audio jack for connecting |
external speakers using Aux cable |
or to plug in headphones |
Power: press for 3 – 4 seconds to power on/off GO; press for a second or less to lock/ unlock GO. If your GO hangs or becomes slower, press for 7-8 seconds to reboot
USB to
Micro USB Cable
Voltage: 220V Frequency: 50 Hz for
input and 5V 1A for output
Aux Cable |
Earphones |
Strapholder |
Connect an Aux cable to the speaker to listen to songs from GO
LEFT SIDE VIEW OF CARVAAN GO
1.SD*: In this mode, enjoy your personal collection of songs stored on your personal micro SD card. SD card mode can also be used as Data Transfer Mode. Here you can transfer your personal collection of song, files etc to and from your Laptop/PC.
2.FM/AM**: Press the mode button to switch between FM & AM. Your earphones act as signal to FM/AM. To use FM (on internal speakers of GO or your own Bluetooth speakers), you will need to plug your earphones into GO
To auto tune FM/AM stations, follow the steps: Step 1: Press play/pause button for 5 seconds
Step 2: Searching for all FM/AM signals will start. You will hear a searching sound & each FM/AM station will play for approx. 3-4 seconds till all stations are tuned
Step 3: Press next/previous button to go to next/previous station
FM frequency: 87.5 to 108 MHZ AM frequency: 520 to 1710 KHZ
Note: It is recommended that you do not put the unit on charge while listening to FM/AM as it will interrupt the signal
3. SD SLOT: open the flap to insert your personal micro SD card
*support for micro SD card capacity less than or equal to 32GB
**AM station will play as per broadcast timings
RIGHT SIDE VIEW OF CARVAAN GO
1. STRAPHOLDER
2. VOL+/- : press to increase /decrease volume
3. BLUETOOTH*** : press this button & follow the instructions to turn on Bluetooth. Go to page 5 for details on how to connect GO to Bluetooth speakers
4. SPEAKER: press to listen to songs on inbuilt speakers of GO
5. CHARGING PORT
***support for BT version 5.0
BOTTOM VIEW OF CARVAAN GO
speaker grill
3
Loading...