Power: press for 3 – 4 seconds to power on/off GO; press for a second or less to lock/ unlock GO. If your GO hangs or becomes slower, press for 7-8 seconds to reboot
USB to
Micro USB Cable
Voltage: 220V Frequency: 50 Hz for
input and 5V 1A for output
Aux Cable |
Earphones |
Strapholder |
Connect an Aux cable to the speaker to listen to songs from GO
LEFT SIDE VIEW OF CARVAAN GO
1.SD*: In this mode, enjoy your personal collection of songs stored on your personal micro SD card
2.FM/AM**: Press the mode button to switch between FM & AM. Your earphones act as signal to FM/AM. To use FM (on internal speakers of GO or your own Bluetooth speakers), you will need to plug your earphones into GO
To auto tune FM/AM stations, follow the steps: Step 1: Press play/pause button for 5 seconds
Step 2: Searching for all FM/AM signals will start. You will hear a searching sound & each FM/AM station will play for approx. 3-4 seconds till all stations are tuned
Step 3: Press next/previous button to go to next/previous station
FM frequency: 87.5 to 108 MHZ AM frequency: 520 to 1710 KHZ
Note: It is recommended that you do not put the unit on charge while listening to FM/AM as it will interrupt the signal
3. SD SLOT: open the flap to insert your personal micro SD card
*support for micro SD card capacity less than or equal to 32GB
**AM station will play as per broadcast timings
RIGHT SIDE VIEW OF CARVAAN GO
1. STRAPHOLDER
2. VOL+/- : press to increase /decrease volume
3. BLUETOOTH*** : press this button & follow the instructions to turn on Bluetooth. Go to page 5 for details on how to connect GO to Bluetooth speakers
4. SPEAKER: press to listen to songs on inbuilt speakers of GO
***support for BT version 4.1
BOTTOM VIEW OF CARVAAN GO
charging port |
3.5 mm audio jack for |
|
connecting external |
|
speakers using Aux |
speaker grill |
cable or to plug in |
headphones |
3