Samsung ML-1510, ML-1700 Disassembly and Reassembly
5
5
5-1
Samsung Electronics
Disassembly and Reassembly
Service Manual
5. Disassembly and Reassembly
5.1 General Precautions on Disassembly
When you disassemble and reassemble components, you must use extreme caution. The close
proximity of cables to moving parts makes proper
routing a must.
If components are removed, any cables disturbed
by the procedure must be restored as close as
possible to their original positions. Before removing any component from the machine, note the
cable routing that will be affected.
Whenever servicing the machine, you
must perform as follows:
1. Check to verify that documents are not stored
in memory.
2. Be sure to remove the toner cartridge before
you disassemble parts.
3. Unplug the power cord.
4. Use a flat and clean surface.
5. Replace only with authorized components.
6. Do not force plastic-material components.
7. Make sure all components are in their proper
position.
Releasing Plastic Latches
Many of the parts are held in place with plastic
latches. The latches break easily; release them
carefully.
To remove such parts, press the hook end of the
latch away from the part to which it is latched.
5-2
Disassembly and Reassembly
Samsung Electronics
Service Manual
1. Pull the Cassette out of the printer.
2. Remove the Front Cover in the direction of
arrow.
3. Remove four screws.
4. Unlatch the front ends of the Top Cover.
5. Remove the Top Cover in the direction of arrow.
6. Remove the Rear Cover from the Top Cover.
Cassette
5.2 Top Cover
Front Cover
Top Cover
Rear Cover
5-3
Samsung Electronics
Disassembly and Reassembly
Service Manual
1. Before you remove the Fuser, you should
remove:
- Top Cover(see page 5-2)
2. Unplug two connectors(Block) from the boards,
then remove four screws.
3. Remove two screws and take the Thermostat
out of the Fuser.
4. Remove two screws and take the Halogen
Lamp out of the Heat Roller.
5. Remove one screw and take the Idle Gear out.
6. Remove four screws and divide the Fuser into
two parts
7. Remove the Thermister from the Fuser Cover.
Idle Gear
5.3 Fuser
5.3.1 Fuser(Heat Lamp Type)
Thermister
Fuser Ass'y
Thermostat
Fuser Cover
Heat Roller
Halogen Lamp
5-4
Disassembly and Reassembly
Samsung Electronics
Service Manual
5.3.2 Fuser(Q-PID Type)
1. Before you remove the Fuser, you should
remove:
- Top Cover(see page 5-2)
2. Unplug two connectors(Block) from the boards,
then remove four screws.
3. Remove two screws and take the Thermostat
out of the Fuser.
4. Remove two screws.
5. Remove one screw and take the Idle Gear out.
Fuser Ass’y
Thermostat
Idle Gear
Loading...