Samsung LTN-173KT01-C01 Datasheet

Approval
TO DATE
SAMSUNG TFT-LCD
SAMSUNG TFT-LCD
MODEL NO : LTN173KT01-C01
MODEL NO : LTN173KT01-C01
NOTE : Extension code [-C01]
www.jxlcd.com
: General : Apr. 20. 2009
www.jxlcd.com
Surface type [ Glare ]
LTN173KT01-C01
The information described in this SPEC is preliminary and can be changed without prior notice.
APPROVED BY :
PREPARED BY :
LCD DEVELOPMENT G1. MOBILE DIVISION
SAMSUNG ELECTRONICS CO., LTD.
Samsung Secret
Doc.No. Rev.No
04-A00-G-090420
Page
/ 31LTN173KT01-C01
1
CONTENTS
Approval
Revision History General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
3.3 LED Driver
4. Block Diagram
4.1 TFT LCD Module
5. Input Terminal Pin Assignment
5.1 Input Signal & Power
5.2 LVDS Interface
5.3 Timing Diagrams of LVDS For Transmitting
5.4 Input Signals, Basic Display Colors and Gray Scale of Each Color.
www.jxlcd.com
www.jxlcd.com
5.5 Pixel format
- - - - - - - - - - - - - - - - - - - ( 3 )
- - - - - - - - - - - - - - - - - - - ( 4 )
- - - - - - - - - - - - - - - - - - - ( 5 )
- - - - - - - - - - - - - - - - - - - ( 7 )
- - - - - - - - - - - - - - - - - - - ( 10 )
- - - - - - - - - - - - - - - - - - - ( 13 )
- - - - - - - - - - - - - - - - - - - ( 14 )
6. Interface Timing
6.1 Timing Parameters
6.2 Timing Diagrams of interface Signal
6.3 Power ON/OFF Sequence
7. Outline Dimension
8. Packing
9. Markings & Others
10. General Precautions
11. EDID
Samsung Secret
- - - - - - - - - - - - - - - - - - - ( 19 )
- - - - - - - - - - - - - - - - - - - ( 22 )
-- - - - - - - - - - - - - - - - - - ( 24 )
-- - - - - - - - - - - - - - - - - - ( 25 )
- - - - - - - - - - - - - - - - - - - ( 27 )
- - - - - - - - - - - - - - - - - - - ( 29 )
Doc.No. Rev.No
04-A00-G-090420
Page
/ 31LTN173KT01-C01
2
REVISION HISTORY
REVISION HISTORY
LTN173KT01-C01 model Preliminary spec was issued first.AllP00Nov. 25. 2008
Approval
SummaryPageRevision No.Date
Feb. 11. 2008
Apr. 20. 2009
P01
14 22 25
LED connection and placement was updated. ( 6 x 10) Power on/off Sequence (additional signal PWM, EN) Packing SPEC (weight, volume, size) was changed.
The Approval SPEC is released.AllA00
www.jxlcd.com
www.jxlcd.com
Samsung Secret
Doc.No. Rev.No
04-A00-G-090420
Page
/ 31LTN173KT01-C01
3
Approval
GENERAL DESCRIPTION
DESCRIPTION
LTN173KT01-C01 is a color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as switching devices. This model is composed of a TFT LCD panel, a driver circuit and a backlight system. The resolution of a 17.3" contains 1600 x 900 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum
viewing angle.
FEATURES
• Thin and light weight
• High contrast ratio, high aperture structure
• 1600 x 900 pixels resolution (16:9)
• Fast Response Time
• Low power consumption
• LED BLU Structure
• DE (Data enable) only mode
• 3.3V LVDS Interface
• On board EDID chip
• Pb-free product
APPLICATIONS
• Notebook PC
• If the usage of this product is not for PC application, but for others, please contact SEC
www.jxlcd.com
GENERAL INFORMATION
www.jxlcd.com
mm382.08 (H) x 214.92 (V) (17.3 ”diagonal)Display area a-Si TFT active matrixDriver element 262,144Display colors
pixel1600 x 900Number of pixel
RGB vertical stripePixel arrangement
mm0.2388 (H) x 0.2388 (V) (TYP.)Pixel pitch
NoteUnitSpecificationItem
16 : 9
Normally whiteDisplay Mode Haze 0, Hardness 3HSurface treatment
Samsung Secret
Doc.No. Rev.No
04-A00-G-090420
Page
Glare
/ 31LTN173KT01-C01
4
Mechanical Information
Approval
Module
size
Note (1) Measurement condition of outline dimension
. Equipment : Vernier Calipers . Push Force : 500g f (minimum)
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENTAL ABSOLUTE RATINGS
Operating temperate
(Temperature of glass surface)
Max.
398.6
233.3
5.8
570
NoteUnitTyp.Min.Item
mm398.1397.6Horizontal (H) mm232.8232.3Vertical (V)
(1)mm--Depth (D)
g540-Weight
NoteUnitMax.Min.SymbolItem
(1)°C60-20 TSTGStorage temperate
(1)°C500TOPR
(2),(4)G240-SnopShock ( non-operating )
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. (40 °C Ta) Maximum wet - bulb temperature at 39 OC or less. (Ta > 40 °C ) No condensation
www.jxlcd.com
www.jxlcd.com
100
-40 -20 0 20 40 60 80
Relative Humidity ( %RH)
90
80
60
40
20
Operating Range
Storage Range
5
0
( 40,90 )
( 50,50.4 )
( 60,27.7 )
Temperature (OC)
(2) 2ms, half sine wave, one time for ±X, ±Y, ± Z. (3) 5 - 500 Hz, random vibration, 30min for X, Y, Z. (4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
(3),(4)G2.41-VnopVibration (non-operating)
Samsung Secret
Doc.No. Rev.No
04-A00-G-090420
Page
/ 31LTN173KT01-C01
5
1.2 ELECTRICAL ABSOLUTE RATINGS (1) TFT LCD MODULE
Approval
Power Supply Voltage
Logic Input Voltage
Note (1) Within Ta (25 ± 2 °C )
DD
DD
DD
DD
VDD=3.3V, V
DD
DD
+ 0.3V + 0.3V
– 0.3V – 0.3V
SS
= GND = 0V
NoteUnitMax.Min.SymbolItem
(1)VV (1)VV
www.jxlcd.com
www.jxlcd.com
Samsung Secret
Doc.No. Rev.No
04-A00-G-090420
Page
/ 31LTN173KT01-C01
6
Approval
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics should be measured in a dark room or equivalent state with the methods shown in Note (5). Measuring equipment : TOPCON SR-3
Contrast Ratio
(5 Points)
Response Time at Ta
( Rising + Falling )
Average Luminance of White (5 Points)
Red
Color
Chromaticity
( CIE )
Green
Blue
www.jxlcd.com
www.jxlcd.com
White
CR
RT
AVE
X
Y
X
Y
X
Y
X
Y
* Ta=25 ± 2°C, VDD=3.3V, fv= 60Hz, f
Normal
Viewing
Angle
φ = 0 θ = 0
0.6440.6140.584R
0.3860.3560.316R
0.3520.3250.292G
0.6340.6040.574G
0.1860.1560.126B
0.1220.0920.062B
0.3430.3130.283W
0.3590.3290.299W
DCLK
= 53.92MHz, IL= 20mA
Unit
-600400
-220185YL,
-
msec
cd/m
-
2
NoteMaxTyp.Min.ConditionSymbolItem
(1), (2),
(5)
(1), (3)-8-T
IL=20mA
(1), (4)
Viewing
Angle
13 Points
White Variation
Samsung Secret
Hor.
Ver.
θ
L
R
H
L
L
CR 10
--40
--40θ
--15φ
--30φ
Degrees
%-60-Color Gamut
-
(1), (5)
SR-3
(6)1.7--δ
Doc.No. Rev.No
04-A00-G-090420
Page
/ 31LTN173KT01-C01
7
Note 1) Definition of Viewing Angle : Viewing angle range(10
Normal Line
o
φ = 0
,
θ = 0
θ
L
φ
H
θL =90
φ
o
x
L
≤≤≤≤
o
C/R)
θ
R
Approval
12 O’clock
y
direction
φH= 90
o
6 O’clock direction
φL= 90
Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)
at 5 points(4, 5, 7, 9, 10)
Points : , , , , at the figure of Note (6).
Note 3) Definition of Response time :
Display data
Optical Response
o
CR(4) + CR(5) + CR(7) + CR(9) + CR(10)
CR =
4 9
www.jxlcd.com
www.jxlcd.com
100%
90%
10%
0%
5
White(TFT OFF) White(TFT OFF)
7
5
10
Black(TFT ON)
T
R
x'y'
θR=90
T
F
o
Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.
(400) ( 800) (1200)
Average Luminance of White ( Y
YL4+ YL5+ YL7+ YL9+ Y
Y
L,AVE
=
Samsung Secret
Doc.No. Rev.No
5
L,AVE
)
L10
10
9
7
5
4
: test point
04-A00-G-090420
Time
VIEW AREA
(225)
(450)
(675)
(lines)
Page
/ 31LTN173KT01-C01
8
Approval
Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement
should be executed. Measurement should be executed in a stable, windless,and dark room. 30 min after lighting the backlight. This should be measured in the center of screen. LED current : TBD mA Environment condition : Ta = 25 ± 2 °C
Photo-detector
( TOPCON SR-3 )
Field
= 2°
50 cm
TFT-LCD module
Center of the screen
[ Optical characteristics measurement setup ]
www.jxlcd.com
www.jxlcd.com
Note 6) Definition of 13 points white variation (
Maximum luminance of 13 points
δL=
Minimum luminance of 13 points
10mm
10mm
13 12
400 800
10
δ
L
1 13
), [ ~ ]
1200
LCD panel
10mm
11
9
225
8
5
3
10mm
Samsung Secret
Doc.No. Rev.No
7
4
2
04-A00-G-090420
6
450
675
(lines)
1
: test point
Page
/ 31LTN173KT01-C01
9
3. ELECTRICAL CHARACTERISTICS
3.1 TFT LCD MODULE
Approval
Ta= 25 ± 2°C
NoteUnitMax.Typ.Min.SymbolItem
Voltage of Power Supply
Differential Input
Voltage for LVDS
Receiver Threshold
Hsync Frequency
Main Frequency
Rush Current
Current of Power
Supply
Note (1) Display data pins and timing signal pins should be connected.( GND = 0V )
(2) fV= 60Hz, f (3) Power dissipation pattern
www.jxlcd.com
www.jxlcd.com
*a) White Pattern *b) Mosaic Pattern
High
Low
White
DCLK
= 53.92 MHz, VDD= 3.3V , DC Current.
DD
IH
IL
H
DCLK
RUSH
I
DD
V3.63.33.0V
V
CM
= +1.2VmV+100--V
mV---100V
Hz-60-fvVsync Frequency
KHz-57-f
MHz-53.92-f
(4)A(1.5)--I (2),(3)*amA-450­(2),(3)*bmA-600-Mosaic
(2),(3)*cmA860730-V. Stripe
VIEW AREA
Samsung Secret
Doc.No. Rev.No
Display Brightest Gray Level
Display Darkest Gray Level
04-A00-G-090420
Page
10
/ 31LTN173KT01-C01
Loading...
+ 22 hidden pages