Samsung HS122JF, HS08XJF User Manual
Ultra mobile SATA
Spinpoint N1C
Capacity
Model
80GB 120GB
HS08XJF HS122JF
FEATURES
• MAX.60GB Formatt ed Capacit y Per Disk • SATA S.M.A.R.T Compliant
• High Speed Digital Signal Processor Based Architecture • SATA 48-bit Address Feature Set
• Low Power HDC • Multi-Burst On-The-Fly Error Correction
• Advanced Power Management Control • SilentSeek™
• Fluid Dynamic Bearing Spindle Motor Technology • Free Fall Sensor (optional)
DRIVE CONFIGURATION ENVIRONMENTAL SPECIFICATIONS
Capacity
Interface
Rotational Speed
Buffer DRAM Si z e
Byte per Sector
PERFORMANCE SPECIFICATION Linear Shock (1/2 sine pulse)
Average Seek time (typical)
Media Transfer Rate (Max.)
Interface Transfer Rate (Max.)
Drive Ready Time (typical )
RELIABILITY SPECIFICATION
Non-recoverable Read Error
Controlled Ramp Load/Unload
ACOUSTICS Height
Idle
Performance Seek
POWER REQUIREMENTS
Voltage
Spin-up Current (Max.)
Seek (typical)
Read/Write (typical)
Idle (typical)
Standby (typical)
Sleep (typical)
1 sector in 10^13 bits Non-operating -400 to 15,000 m
80 / 120 GB
SATA 1.5Gbps Operating
5400 RPM class Non-operating
8 MB
512 Operating
14.0 ms Operating, 2ms 600 G
550 Mb/s Non-operating, 1ms 1500 G
1.5 Gbps
4.0 sec Operating 0.67 Grms
600,000
2.4 Bel
2.6 Bel
+3.3V ±5%
540 mA
1.30 W
1.60 W
0.40 W
0.12 W
0.10 W
Temperature
Humidity (non-condensi ng)
Non-operating
Vibration
Altitude (relat i ve to sea level)
Operating -300 to 3.000 m
PHYSICAL DIMENSION
Width
Length
Weight (Max.)
* Note : Design and specifications are subject to change without prior notice.
1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
* Accessible capacity may vary as some OS uses binary numbering system for
reported capacity.
* A small portion of the (8MB) buffer memory is reserved for firmware use.
5 ~ 60 ℃
-40 ~ 85 ℃
8 ~ 90 ％
8 ~ 90 ％
8.0 mm
78.5 mm
54.0 mm
62 g
1.8" N1C SATA product specification Rev.08
Match with 1.8" N1C SATA product manual Rev.07
Loading...