Samsung AW18PHBC, AW12PHBA, AW18PHBA, AW12PHBC, AW18PHB User Manual

...

USER'S MANUAL

AW08PH Series AW08PK Series

AW12PH Series AW12PK Series AW18PH Series AW18PK Series AW24PH Series AW24PK Series AW122PB

E S

DB98-26004A(4)

Window-type Room Air Conditioner (Cooling)

E-2

Safety Precautions

The following safety precautions must be taken when using your air conditioner.

WARNING

Risk of electric shock. • Can cause injury or death. • Disconnect all remote electric power supplies before servicing, installing or cleaning.

• This must be done by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard.

DURING OPERATION

Users of this product are cautioned not to attempt repair of this product at their own discretion. Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased.

Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center.

Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. Keep children away from the unit.

Do not place any obstacles in front of the unit.

Do not spray liquid of any kind into the indoor unit. Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist.

Make sure that the unit is correctly ventilated at all times: Do not place clothing or other materials over it.

If the wireless remote control will not be used for a long time, remove the batteries. (If applicable)

When using a wireless remote control, the distance should not be more than 7 meters from the air conditioner. (If applicable)

The air conditioner must be plugged into its own specific power source, which must be installed in compliance with national wiring,earthing and safety regulations.

If the power cord is damaged in any way, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

This device must be installed according to the national electrical rules.

The appliance must be installation that the plug should be easily accessible after installation.

If the fuse on PC board is broken please change it with the type of T 3.15A 250V.

The breaker of the air conditioner should be all-pole switch; and the distance between its two contacts should be no less than 3.5mm. Such means for disconnection must be incorporation in the fixed wiring.

DISPOSING OF THE UNIT

Before throwing out the device, it is necessary to pull back the battery cells and get rid of them safely for recycling reasons.

When you need to dispose of the unit, consult your dealer. If pipes are removed incorrectly, refrigerant may blow out and come into contact with your skin,causing injury. Releasing refrigerant into the atmosphere also damages the environments.

Please recycle or dispose of the packaging material for this product in an environmentally responsible manner.

THERS

Never store or ship the air conditioner upside down or sideways to avoid damage to the compressor.

The appliance is not intended for use by young children or infirm persons without supervision: Young children should be supervised to ensure that they do not play with the appliance.

Max current is measured according to IEC standard for safety and current is measured according to ISO standard for energy efficiency.

E-3

 PREPARING YOUR AIR CONDITIONER

n Safety Precautions ........................................................................................ 2

n Air Conditioning Unit-Main Parts, Buttons and Display ................................. 4

n Remote Control-Buttons ................................................................................ 5

n Getting Started .............................................................................................. 6

n Inserting the Remote Control Batteries ........................................................ 7

 OPERATING YOUR AIR CONDITIONER

n Cooling Your Room ....................................................................................... 8

n Airing Your Room .......................................................................................... 9

n Removing Excess Humidity........................................................................... 10

n Adjusting the Air Flow Direction Horizontally ................................................ 11

n Adjusting the Air Flow Direction Vertically .................................................... 11

 PROGRAMMING YOUR AIR CONDITIONER

n Setting the On Timer ..................................................................................... 12

n Setting the Off Timer ..................................................................................... 13

Selecting Good Morning mode

........................................................................ 14

n Selecting Energy saving mode ...................................................................... 15

 RECOMMENDATIONS FOR USE

n Temperature and Humidity Ranges .............................................................. 15

n Cleaning Your Air Conditioner ....................................................................... 16

n Solving Common Problems ........................................................................... 17

Technical Specifications

.................................................................................. 18

 INSTALLATION............................................................................................. 19

Contents

CAUTION

“The high inrush current of the starting compressor motor can have adverse effects to the operation of other equipment under unfavorable mains conditions. This equipment does not comply with the relevant technical standards for the limitation of voltage fluctuations and flicker.” Before connection this equipment to the power supply system, please report to your suply authority and obtain the consent. Do not connect other electric appliances to the same supply lines.

The maximum permissible system impedance at the power junction box is 0.24 ohms. Usually, the maximum permissible mains impedance will not be exceeded when the branch to the power outlet is fed from a junction box with a rated current of 32A.

AW18

E-4

Air Conditioning Unit - Main Parts, Buttons and Display

Air inlet (Inside)

The air filter is located in side

Air Outlet

Inner air flow blades (right/left orientation)

Outer air flow blades (up/down orientation)

Air inlet (Outside)

Ventilation lever



The power plug may be not supplied

depending on the model.

Power plug

The type of the power plug may differ according to the type of local power supply.

Temperature adjustment

buttons

Air flow blade

swing button

Fan speed adjustment

button

Good Morning setting button

Timer setting button

Operating mode selection button (COOL,DRY, FAN)

Energy Saver button

Timer indicator

Good Morning indicator

Operating mode indicators (COOL, DRY,FAN)

Energy Saver indicator

Remote Control sensor

Temperature/

Timer setting

On/Off button

The design and shape are subject to change according to the model.

E-5

Remote Control - Buttons

Timer setting button

Selecting Good Morning

button

Operating mode

selection button

Energy Saver button

Air flow blade swing button

Temperature adjustment button

On/Off button

Fan speed adjustment button

E-6

You have just purchased a window-type room air conditioner and it has been installed by your

installation specialist.

Your Owenr’s Instructions contain valuable information on using your air conditioner.

Please take the time to read them as they will help you take full advantage of the unit’s functions.

This Owner’s Instructions is just for using your air conditioner correctly.

Thus, the illustrations shown in this manual may not exactly match your air conditioners.

The booklet is organized as follows.

 The following figures are shown on pages 4 and 5:

- Air conditioning unit (main parts, buttons and display)

- Remote control (buttons)

They will help you find the buttons and understand the symbols displayed.

 In the manual, you will find a series of step-by-step procedures for each function available.

The illustrations in the step-by-step procedures use four different symbols:

 

PRESS PUSH IMPORTANT NOTE

Moreover,applicable, wherever the illustrations show the positions of the buttons on both the

remote control and the unit itself.

For the... The illustrations have a...

Remote control Gray background.

Example:

Unit itself White background.

Example:

Getting Started

E-7

Inserting the Remote Control Batteries

You must insert or replace the remote control batteries when:

 You purchase the air conditioner

 The remote control does not work correctly



Use two AAA, LR03 1.5V batteries. Do not use old batteries or different kinds of batteries together.

Batteries may be completely discharged after 12 months, even if they have not actually been used.

1 Push the battery cover on the rear of the remote control with your thumb in

the direction of the arrow and remove it.

2 Insert the two batteries,taking care to respect the polarities:

 + on the battery with + on the remote control  - on the battery with - on the remote control

3 Close the cover by sliding it back unitl it clicks into place.

Result: You can control all the functions your air conditioning unit directly from your seat, using the remote control.

+ 15 hidden pages