Samson DOUBLE BRAID User Manual

SAMSON SPLICING INSTRUCTIONS

5 fids

Mark X

Mark R

Special Tips: Splicing Double Braid Rope

Splice With thimble

Follow Step 1 of the Eye Splice Double Braid Class I for determining the correct
eye size. When burying exposed core, as in Step 8, bury to crossover, then insert
thimble into eye before milking cover all the way. If using a thimble with ears, before
inserting cover into core, as in Step 5, insert core through the rings (dog ears) and
slide thimble beyond Mark 3. Proceed to make the splice according to instructions.

Note: Before nal burying, slide thimble around to cover side of eye. To secure
nished eye tightly around thimble, either whip throat or dip the eye in hot water
for several minutes. Hot water will shrink the eye tightly around thimble for nylon
and polyester ber ropes.

Splicing RopeS 3" diameteR oR laRgeR

Before splicing rope, measure back 8 ds and insert a large d through the rope to anchor the core and cover

together. Use a milking strap to milk slack of cover toward end of rope. A milking strap is a smaller diameter rope
that is cinched around the rope to create more seizing power than a human hand can apply. It helps to pull the
milking strap with mechanical means (a winch or come-along.) Cut off any excess cover.

Milking the cover is a crucial step and will be done several times during this splice. The milking
process aligns the core and cover braid angles and allows them to more effectively share
the load when the rope is in use. It is best done with a milking strap
for ropes 3" diameter or larger.

After milking, check for cover slack. If cover slack remains,
repeat milking process until slack is gone.

minimum lengthS

Minimum eye-and-eye sling length with Class I

Double Braid is 5 d lengths from extraction Mark X
to extraction Mark X, regardless of rope diameter.

The size of eye does not affect the minimum length.

Mark X

Mark R

Example: How to make an Eye-and-Eye Sling

10' long overall with two 6" eyes:

10 ft.

6"

Measure and cut a length:

1 Eye

10 ft.

Circ. 3 fids

Mark X

6"

end-FoR-end Splice

Minimum endless loop (Grommet) with Class I Double

Braid is 10 d lengths between extraction Mark X to
extraction Mark X, regardless of rope diameter.

Mark X

Exact overall lengths with endless loops are determined by
allowing for extra rope consumed in making the End-for-End
Splice. The length of extra rope is equal to 4 fid lengths.

Example: To make an endless loop 10' overall:

10 Ft.

Measure and cut a length:

20 Ft.

4 fids

DOCUMENT DblBrd_Special Tips_SEPT2012.pdf PAGE 1 OF 1

SamsonRope.com | Email [e-mail] | Tel [phone]

© 2012 Samson Rope Technologies, Inc. All rights reserved. S/WD #108294 7/2012