Page 1
ANGLOPACK
Quick Setup Guide
Required configuration
- A standard line: non-shared analog (excluding “Numeris” and switchboard)
- A subscription to the ADSL service AngloPack from Teleconnect
- A standard telephone (optional)
- A computer with the following characteristics:
• PC running Windows 98SE, 2000, Me, XP, Vista, Seven
• Memory: 512 MB minimum, 1 GB recommended
• An Ethernet port (preferred)
• Wi-Fi (optional)
Apple computers running Mac/OS or computers running Linux are not supported.
Replace the dashes with your France Telecom telephone number
ADSL Username _ _ _ _ _ _ _ _ _ _ @budget.btadsl
ADSL Password _ _ _ _ _ _ _ _ _ _
It works though but our technical support is not guarantee in this case
1
Sagem F@st 3102 modem
Page 2
In your package you will find:
Telephone cable RJ11 X 1
Connector RJ11 male/male, Grey
Female telephone adaptor X 1
Telephone socket adaptor / RJ11 female, Beige
Ethernet cable RJ45 X 1
Connector RJ45 male/male, Yellow
External ADSL filter X 1
Adaptor Male/femelle / RJ11 female
Your Wi-Fi box X 1
Sagem F@st 3102 modem/router
Electrical power supply and cable X 1
Transformer 220V
Telephone cable RJ11 X 1
Connector RJ11 male/male
2
1
4
6
3
2
7
5
Page 3
Installation
1/ Configure your PC network
•
The Internet Protocol properties must be set to the following :
- obtain an IP address automatically
- obtain a DNS address automatically
•
To configure the network on your PC, please check your computer
users’ guide.
2/ Connect your equipment
•
As described in the « wiring diagram » enclosed on page 4
•
When the cabling is complete, the auto-configuration will launch
automatically. Please be patient and do not touch anything before
the light @ is green and steady and the light is on (this should
take about 5 min)
3/ Login procedure
•
The login information will normally be auto-configured in
your box, and you will be connected to the Internet
automatically.
•
However, in a few cases, your ADSL login details may be
requested (particularly after a box RESET). In this case, please
enter them, as stated on page 1 of this guide and follow the
instructions :
Access the box configuration interface
•
To do so, please open Internet Explorer (or another Web browser)
- in the address bar, please type in :
http://192.168.1.1
- a login dialogue window will appear.
- please enter the following information :
Login User Profile:
user
(no password)
Then select: Point-to-Point Protocol over Ethernet (PPPoE)
Enter then your login details as stated in page 1, in the
corresponding fields (User Name & Password):
Note
: VPI must have a value of 8 and VCI must have a value of 35.
Validate by clicking on
3
Page 4
Wiring Diagram
4
BOX
Main
Telephone
socket
PPOOWWEERR
BOX
(REAR FACE)
Ma
le RJ11
cable
ON/
OFF
PWR REG
ETH1 ETH2
ADSL
RST
During an electrical storm
disconnect the box from the
mains and telephone socket
Electric
Socket
A
DSL
ETH1
Male RJ45
Ethernet
Cable
Please ensure you have connected
the ADSL filter provided to your
telephone socket.
or Wi-Fi (no cable) if enabled
on both the modem & your
computer
Should you wish to connect a second phone, you will need to do so on a
second wall socket, using another ADSL filter (not provided).
Please do not hesitate to ask our technical support and/or customer service
for help & connection validation.
ADSL
filter
Second
telephone
socket
Page 5
Wi-Fi configuration (optional)
For your convenience, the Wi-Fi interface of your
box is enabled by default. However, you may
choose to enable/disable it. To enable/disable
Wi-Fi, please follow the instructions here below:
1/ Access the box configuration interface:
•
To do so, please open Internet Explorer (or any similar Web
browser)
- in the address bar, please type in :
http://192.168.1.1
- a login dialogue box will appear.
- please enter the following information :
Login User Profile:
user
(no password)
2/ Enable/disable Wi-Fi
•
In the interface, please click on “wireless network”, in the left hand
side menu. Then click on ” SSID1”, select the status “Enabled” or
“Disabled” on the drop down menu.
•
Validate by clicking on
3/ Follow the Wi-Fi instructions of your PC
•
You will also need to configure the Wi-Fi device of your computer.
As these devices are different on each computer, we advise you
to refer to your computer user guide or to contact the technical
assistance of its manufacturer should you have any doubt.
•
Please connect to the wireless network named "FAST3102 xxxxxx"
(where xxxxxx is an alphanumerical reference particular to each box)
•
During this process, you will be asked for a WPA encryption key.
This key is printed underneath your router. Please type in this key
carefully in uppercase without any dots or spaces.
5
Page 6
What to do if a problem arises?
Event Test procedure or possible cause
The Power light is off
Please check that the power supply block is properly plugged in.
Check that the power supply cable is properly connected to your router.
Check that the electrical socket is in working order by plugging a different device into.
Check your fuse box and your central electricity supply.
I can’t connect to the Internet in Ethernet mode
Please check that the Ethernet cable is properly connected to your computer and to your box.
Check that your computer is properly configured to enable Internet access (network configuration menu).
I can’t configure my Modem in Wi-Fi mode
By default the Wi-Fi is active. However, it may have been deactivated for some reason. In this case, you need to activate it again
through the box interface.
I can’t connect in Wi-Fi mode
Please check that the encryption WPA key has been entered as it is written underneath the box respecting uppercase and without
any spaces.
Wi-Fi is configured properly but I still can’t connect in
Wi-Fi mode
Please check that the box is in working order (lights on), that your computer’s Wi-Fi adaptor is set to WPA encoding and TKIP/AES
encryption and that you have properly entered the WPA key as stated underneath your box. You can also try to move your
computer closer to the box. If Wi-Fi does not work in your house, please check our powerline solution on www.budget-boutique.com
I can’t connect several computers to the box
Please check that each new computer is connected properly to the box (by Ethernet or Wi-Fi) and that the method used is correctly
configured on each computer.
I can’t surf on the Internet Please reboot the box using the ON/Off switch at the back of the box.
My internet pages “freeze” Reboot the box using the ON/Off switch at the back of the box.
When I pick up the telephone, I hear a loud buzz You probably have not placed an ADSL filter on your main or secondary telephone wall socket.
F R E E T E C H N I C A L A S S I S T A N C E
Open Monday to Thursday from 9:30am to 6:00pm and Friday from 9:30am to 5:00pm
by phone: 0805 111 555 (free from your landline) or 0811 43 72 14 (local cost call)
or by e-mail: support@teleconnect.fr
For non-technical assistance: 0805 02 4000 (free from your landline)
6
Loading...