Sagem AP1100 User Guide

User Guide

Photo Printer AP1100

*252780533B*

AgfaPhoto Holding GmbH, www.agfaphotoprinter.com,
AGFAPHOTO is used under license of Agfa-Gevaert AG,
produced for and sold by Sagem Communication, www.sagem.com

AP1100 n-b.book Page 1 Jeudi, 21. septembre 2006 11:17 11

ENGLISH

Welcome

Thank you for purchasing our new photo printer. With this high quality printer you can get the most
out of your digital photos.
The "Crystal Image" and "Red-eye" image optimising functions provide faultless print and copy quality
of your photos.
You will also find the following on the web site www.agfaphotoprinter.com:

• print drivers for PCs,

• a list of answers to frequently asked questions (FAQ).

Safety instructions and recommendations

Do not install your photo printer in a humid room (bathroom, laundry, kitchen, etc.), or within

1.50 m of a tap or water source, or outside. The printer should be operated within an ambient
temperature range of 10 °C to 35 °C. Your printer should be used at an ambient temperature
of between 15°C and 35°C for optimum printing results.
Do not set up your printer in a dusty environment as dust deposits might adversely affect the
print quality of your photos.
Only use the power supply that is supplied (PF60N24AS0 of Shanghai Moons' Automation
Control Co., Ltd). Connect it to a mains outlet in compliance with the installation instructions in
this booklet and the indications stated on the identification label located on the unit (voltage,
current and frequency of the electricity network). As a precaution, in case of danger, the mains
adapters act as a disconnecting mechanism for the 230V power supply. They should be placed
near the device and should be easily accessible.
Never open the top cover when the printer is operating, as you risk breaking the film that may
result a printer malfunction.

avoid injury, never touch the print head.

After using the printer, wait a few moments after switching the printer off before opening it. To

Only use AgfaPhoto consumables, if not you are likely to damage the equipment and
invalidate the guarantee. To obtain the references of the consumables, refer to paragraph
Consumables, page 7.
The CE marking certifies that the product meets the main requirements of the European
Parliament and Council directive 1999/5/CE on telecommunications terminal equipment,
regarding safety and health of users, and regarding electromagnetic interference.
The declaration of compliance can be consulted on the site www.agfaphotoprinter.com, or
can be requested at the following address:

AP1100 is produced for Sagem Communication and distributed or sold by Sagem Communication

AGFAPHOTO is used under licence of Agfa-Gevaert AG

Sagem Communication - Customer relations department

4, rue du Petit Albi - 95800 Cergy Saint-Christophe - FRANCE

1

AP1100 n-b.book Page 2 Jeudi, 21. septembre 2006 11:17 11

Environment

Preservation of the environment as part of a sustainable development logic is an essential concern of
AgfaPhoto. The desire of AgfaPhoto is to operate systems observing the environment and consequently it
has decided to integrate environmental performances in the life cycle of its products, from manufacturing to
commissioning, use and elimination.

PACKAGING

BATTERIES

THE PRODUCT

In this way you can participate in the re-use and upgrading of Electrical and Electronic Equipment Waste,
which can have an effect on the environment and human health.

The presence of the logo (green dot) means that a contribution is paid to an approved national
organisation to improve packaging recovery and recycling infrastructures.
To facilitate recycling, please respect the sorting rules set up locally for this kind of waste.

If your product contains batteries, they must be disposed of at appropriate collection point

The crossed-out waste bin stuck on the product means that the product belongs to the family of
electrical and electronic equipment.
In this respect, the European regulations ask you to dispose of it selectively:

- At sales points in the event of the purchase of similar equipment.

- At the collection points made available to you locally (drop-off centre, selective collection, etc.).

2

3

AP1100 n-b.book Page 3 Jeudi, 21. septembre 2006 11:17 11

Your printer and its accessories

Place your set in front of you. Take out the various components for your printer and check that the
components shown below are present :

A power cable A power supply

A printer A paper tray

A pack of photo
paper (depending
on model)

CD-Rom

A ribbon (depending on
model)

3

3