Ryobi RY39506 User Manual

9

5

7

8

1

Help Line!

®

990000802

10-22-13 (REV:01)

3

NOTICE

Do not use E15 or E85 fuel (or fuel

containing greater than 10% ethanol) in

this product. It is a violation of federal

law and will damage the unit and void

your warranty.

ENGINE STARTING PROCEDURE

4

choke lever to RUN position.

6

Go to www.ryobitools.com and register your new tool on-line.

SET

For additional registration instruction, refer to operator’s manual.

Your Product has been fully tested prior to shipment to ensure your complete satisfaction.

Troubleshooting tips are also available in your operator’s manual.

For any questions about operating or maintaining your product, call the Ryobi

LL

A
C

www.ryobitools.com

1-800-860-4050

WARNING: This Engine Starting Procedure is not a substitute for

reading the operator’s manual. To reduce the risk of injury, user must

read and understand operator’s manual before using this product.

50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with

1 gallon of fresh gasoline in separate gas

container. Shake. Pour into fuel tank.

GAS

2.6

oz.

1

press the primer bulb 10 times.

starter grip and rope (4 times) until engine attempts to start.

choke lever to FULL position.

Lay the TRIMMER on a flat, bare surface.

2

PRIME

10x

3

SET

Do not squeeze throttle trigger.

4

PULL

5

choke lever to HALF position.

SET

CHOKE

HALF

6

starter grip and rope until engine starts (6 times max.).

PULL

7

PRESS and HOLD switch until

After 10 seconds,

Squeeze throttle trigger lock and throttle trigger.

engine stops

To Stop:

8

9