INSTALLATION AND USER’S MANUAL
CONTENT |
|
INTRODUCTION |
2 |
SAFETY PRECAUTION |
2 |
SPECIFICATION |
3 |
INSTALLATION |
4-5 |
DESCRIPTION OF COMPONENTS |
6 |
OPERATION |
6 |
MAINTENANCE |
7 |
TROUBLESHOOTING |
8 |
CONFORMITY WITH DIRECTIVES |
8 |
ENVIRONMENTAL PROTECTION |
9 |
1
INTRODUCTION
Thank you for choosing this cooker hood.
This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safety, please read this instruction manual carefully before installation and usage.
The cooker hood uses high quality materials, and is made with a streamlined design. Equipped with large power electric motor and centrifugal fan, it also provides strong suction power, low noise operation, non-stick grease filter and easy assembly installation.
SAFETY PRECAUTION
□Never let the children operate the machine.
□The cooker hood is for home use only, not suitable for barbecue, roast shop and other commercial purpose.
□The cooker hood and its filter should be clean regularly in order to keep in good working condition.
□Clean the cooker hood according to the instruction manual and keep the unit from danger of burning.
□Forbid the direct baking from the gas cooker.
□Please keep the kitchen room a good convection.
□Before connecting this appliance check that the power supply cord is not damaged. A damage supply cord must be replaced by qualified service personnel only.
□There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels;
□The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels;
□Regulations concerning the discharge of air have to be fulfilled.
□This appliance if not intended for use by persons(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person slide for their safety.
□Children should be supervised to ensure that they do not play with the appliance.
□Do not flame under the range hood.
□The range hood is not intended to be installed over a hob having more than four hob elements
Electrical Shock Hazard
□Only plug this unit into a properly earthed outlet. If in doubt seek advice from a suitably qualified engineer.
□Failure to follow these instructions can result in death, fire, or electrical shock.
2
Standard Installation Accessories List
Spec. |
Illustration Picture |
Qty |
|
|
|
Casing |
|
1 |
|
|
|
Upper Chimney 600mm |
|
1 |
|
|
|
Lower Chimney 600mm |
|
1 |
|
|
|
Hanging Board |
|
1 |
|
|
|
Screws M6×60 |
|
8 |
|
|
|
φ8 Rawl Plugs |
|
11 |
φ8×φ6 white color |
|
|
|
|
|
Screws |
|
11 |
ST6.0×40 |
|
|
φ7.2 Screws |
|
4 |
ST4.0×8 |
|
|
Screws M5x12 |
|
40 |
|
|
|
Washers |
|
16 |
|
|
|
Nuts |
|
16 |
|
|
|
|
3 |
|
CEILING MOUNTING INSTALLATION
1)Position the hanging plate on the
ceiling and then mark the position of the screw holes.
The hanging plate should be securely fixed to the ceiling,
11 x ST6 (40 mm)screws for wooden ceiling
8 x expansion bolts for cement ceiling
2)Fix the angle bars to the hanging plate, using the 8 x M5 screws.
3)Extend the angle bars to the repuired height and then fix them in position using the 16 x M5 screws and nuts with metal washers.
IMPORTANT: The angle bars must have an overlap of AT LEAST 100 mm.
4)If your cooker hood is going to be used in extraction mode, then you should connect the ducting hose to the ceiling adaptor at this point.
Fix the upper chimney section to
the hanging plate, using the 4 x self tapping screws.
Slide the lower chimney section onto the angle bars and raise it until it sits just below the upper chimney section.
4
5) If the glass canopy has not been pre-assembled by the factory, then it should be fixed to the top of the main body of the cooker hood at this stage.
6) Lift the main body of the cooker hood onto the angle bar and then fix it into position using the 16 x M5 screws. IMPORTANT: This stage of the installation process MUST be
completed by two people.
IMPORTANT: The 16 x M5 screws MUST be securely tightened.
7) If you are going to be using the hood in
extraction mode, you should fix the ducting
hose to the spigot.
The electrical |
connection must |
correspond |
to the |
electrical |
||
repuirement noted on the rating |
plate, |
which is placed inside |
the |
|||
cooker hood. |
The appliance should |
now be |
connected |
to |
the |
|
electrical supply. |
|
|
|
|
|
|
Check that the appliance is operating correctly by selecting each speed and switching the light bulbs on and off.
Remove the hanging hook and then slide the lower chimney section downwards, until it rests against the main body of the cooker hood.
Use a stainless steel cleaner and polish on the stainless steel sections of the appliance.
If you are using the appliance in recirculation mode, then you should now fit the carbon filter.
5
DESCRIPTION OF COMPONENTS
STANDBY MODE.
After plug in, all lighting, system in STANDBY MODE.
Low Speed button
It’s used for Ventilation on the kitchen. It is suitable for simmering and cooking which do not make much steam.
Medium Speed button
Airflow speed is ideally for ventilation in standard cooking operation.
High Speed button
When high density of smoke or steam produced, press high-speed button for high effective ventilation.
Booster button
Depress this button to enter into highest speed and again to turn off motor.
Light & Timer button
Short press for lamp control.
Keep pressing the light/timer icon for 2-3 seconds to active the quick timer function.
During the count down, you can press light/timer icon one more time to stop the quick timer function.
Remark: other button (speed, light) can still workable during quick timer function.
6