Rollei Giro90, Giro70, Giro105 User Manual
Rollei Giro 70, Giro 90, Giro 105
Owner´s Manual
GB
! Shutter release
" Zoom buttons Tele/Wide
§ LC display
$ Rewind-button
$
!
"
/
)
§
(
&
= Flash mode button (flash)
Q Exposure mode button (mode)
W Master switch (on/off)
E Autofocus-LED, green
%
/
Q
=
W
R
E
T
Z
% Flash unit
& Lens
/ Autofocus window
( Exposure sensor
) Red-eye reduction LED
+ Self-timer LED
R Viewfinder
T Film-type window
Z Back release
Congratulations on your new
Rollei Giro! Please read these
instructions carefully before using the camera so you will be
able to make full use of all its
functions.
LIQUID-CRYSTAL DISPLAY / ICONS
AUTO
BULB
Please note
The camera’s shutter release
locks in the following cases:
No battery loaded or battery
›
empty.
Camera switched off.
›
Lens cover closed.
›
During zooming or film rewind.
›
When rewound film is left in
›
camera.
While flash is charging.
›
Shooting modes
Self-timer
Continuous shooting
Portrait zoom
Infinity setting
Time exposure
Flash modes
Autoflash
Red-eye reduction
Fill flash
Flash off
Additional icons
Battery low
Battery empty
Battery ok – no display
Film loaded
VIEWFINDER
!
"
$
§
Viewfinder informations
! Frame area
" Parallax marks for close-ups
§ Autofocus area
$ Green AF LED
Switch camera off.
›
Open battery compartment.
›
Load fresh battery (use
›
exclusively CR2 lithium
battery), checking for proper
polarity.
Click compartment cover
›
shut.
Checking battery power
Check battery icon in LCD for
›
power level.
LOADING FILM LOADING THE BATTERY
¤
Sensor
Release back lock, open back
›
and load film cartridge.
Pull out film leader as shown.
›
The film should be flat on its
guides, its bottom perforation
about 1 cm in front of the sensor.
Close camera back until it
›
clicks shut.
The camera automatically ad-
›
vances the film up to frame
No. 1.
The LCD will display frame 1
›
or, if the film is loaded incorrectly, E for ERROR.
The camera automatically de-
›
tects the speed of DX-coded
films.
Loading...