Rockwell Automation 97331001 User Manual

Gate Scaling Module (Part No. 97331001)

Installation Instructions

ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to
comply may result in personal injury and/or equipment damage.

ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.

Follow these instructions to properly mount the Gate Scaling Module:

• Mount to a flat, grounded, metal panel.

• Mount in a suitable enclosure, in a clean, dry location. Contamination from
oils, corrosive vapors, and abrasive debris must be kept out of the enclosure.

• Mount in a horizontal position only, in order to provide proper cooling. The
lettering on the face of the unit should be in a readable position, as shown
below.

60.5 mm
(2.38 in.)

37.25 mm
(1.47 in.)

(Center Diameter)

Notes:
Module Depth = 31.0 mm (1.22 in.)
Mounting Holes: 4.25 mm (0.17 in.)

INPUT OUTPUT

GATE SCALING

MODULE

Part No. 97331001

Engineered byEngineered by

124.0 mm
(4.88 in.)

138.0 mm

(5.43 in.)

Publication DSSD3P-IN004A-EN-P

www.rockwellautomation.com

A

A

Power, Control and Information Solutions

mericas: Rockwell Automation, 1201 South Second Street, Milwaukee, WI 53204-2496 USA, Tel: [phone],

Europe/Middle East/Africa:

sia Pacific: Rockwell Automation, Level 14, Core F, Cyberport 3, 100 Cyberport Road, Hong Kong, Tel: [phone], Fax: [phone]

Rockwell Automation SA/NV, Vorstlaan/Boulevard du Souverain 36, 1170 Brussels, Belgium, Tel: [phone], Fax: [phone]

Publication DSSD3P-IN004A-EN-P - February 2011

Copyright © 2011 Rockwell Automation. All rights reserved. Printed in the U.S.A.

Fax: [phone]