Rockwell Automation 2711P-RVAC User Manual

Installation Instructions

Power Terminal Block

(Catalog Number 2711-TBDC, 2711P-RVAC)

These document provides instructions on how to remove and install the DC or AC Power Terminal Block in the following devices:

Cat. No. Power Type Terminal Type

2711-TBDC DC PanelView 300 Micro

PanelView 600 Touch only PanelView Plus 400-600

2711P-RVAC AC PanelView Plus 400-600

Removing and Installing the Power Terminal Block

You can remove and re-install the power terminal block for ease of installation, wiring and maintenance. A terminal block is pre-installed on each device when shipped.

WARNING

ATTENTION

Explosion Hazard

• Substitution of components may impair suitability

for hazardous locations.

• Do not disconnect equipment unless power has

been switched off and area is known to be non-hazardous.

• Do not connect or disconnect components unless

power has been switched off.

• All wiring must comply with N.E.C. articles

501-4(b), 502-4(b), 503-3(b) as appropriate.

• Peripheral equipment must be suitable for the

location it is used in.

AC and DC terminal blocks are keyed and marked differently so be sure to follow the markings. Do not force terminal blocks into connectors to prevent potential damage to terminal.

The procedure for removing and installing the power terminal block is similar for all terminals. Orientation of the power terminal block may vary between the terminals.

1 Publication 2711-IN021B-EN-P

To remove and install power terminal block:

ATTENTION

Disconnect all power before removing or installing components. Failure to disconnect power may result in electrical shock and/or damage to the terminal.

PanelView 300 Micro & 600 Touch Only

To remove terminal block:

1. Insert tip of small, flat-blade, screw driver into terminal block access slot.

2. Gently pry terminal block away from terminal to release locking mechanism

To install terminal block:

1. Press terminal block base in first with block leaning outward.

2. Genty push top of terminal block back to vertical position to snap in locking tab.

The location of the power terminal block on the PV600 Touch terminal is different but the procedure for removing and installing the terminal block is the same.

PanelView Plus 400 - 600 Terminals