RocketFish RF-HTS210 Quick Setup Guide
8-outlet Power Manager
With Surge Protection
and Noise Filtering
RF-HTS210
Congratulations on your purchase of this Rocketsh Power Manager
with surge protection and noise ltering.
Your power manager:
• Reduces energy consumption to save environmental resources
and lower your electric bill
• Provides surge protection for sensitive electronic devices
• Incorporates noise ltering to provide clean power that will
maximize the performance of your devices.
Features
QUICK SETUP GUIDE
Before using your new product, please read these
instructions to prevent any damage.
1 Main power switch/circuit breaker – controls power to all AC
outlets on the Power Manager, and allows the unit to be reset in
the event of a circuit overload (after the overload condition has
been resolved).
2 6 ft (1.8 m) Soft-Flex™ power cord with right-angle/o-set
plug – enables placement of the Power Manager in the desired
location. The right-angle plug allows you to place furniture as
close as possible to the wall and not block the second AC outlet.
3 One master outlet - controls power to the ve
master-controlled outlets.
4 Three AC adapter spaced outlets – accommodate bulky AC
adapter plugs.
5 Five master-controlled outlets – When the Energy Savings
Switch is ON, these outlets automatically shut down to conserve
energy when the device plugged into the master outlet is
turned o. When the Energy Savings Switch is OFF, these outlets
are always-on.
6 Two always-on outlets – provide continuous power regardless
of Master/Master-controlled outlets state.
7 Power LED indicator - lights to indicate that the power
manager is receiving adequate power from the AC outlet.
8 Protected LED indicator - lights when the surge protection
feature is working properly. If this LED does not light or goes out,
the surge protection feature has reached full capacity and can
no longer absorb additional surges and spikes. The power
manager should be replaced if this light goes out.
9 Grounded LED indicator – lights when a properly grounded AC
outlet is detected. If this LED does not light, we recommend that
you contact a certied, licensed electrician to inspect your
wiring.
10 Energy Savings (ES) Switch – Turn this switch ON to enable
Energy Savings (the master-controlled outlets are shut down
when the the device plugged into the master outlet is turned
o.) When this switch is OFF all outlets are always-on.
11 Coaxial cable surge protection – protects your incoming
coaxial cable line from surges and spikes.
Additional features
• 3,150 joules surge protection – protects your equipment
from damaging power surges and spikes.
• 58 dB EMI/RFI noise ltering – ensures that your equipment
receives only clean power for maximum performance.
• Audible alarm – sounds when the surge protection feature has
reached full capacity and can no longer absorb surges and
spikes. The power manager should be replaced if this alarm
sounds.
• Power cord labels – attach these labels to your power cords
(near the plug end) to help identify which cord is attached to
which device in the event that one should need to be
unplugged for any reason. The labels are pre-printed for
convenience, and the blank labels can be customized for
unique devices.
Operating instructions
1 Plug your power manager’s power cord into a standard 120V AC
outlet. If the LEDs do not light, press the main power
switch/circuit breaker on the front of your power manager.
2 Plug your primary home theater device, such as a TV, into the
Master outlet on your power manager. When you turn o this
device or it goes into sleep or standby mode, the devices
plugged into the Master-controlled outlets automatically shut o
to save power.
Note: This feature is enabled when the Energy Saving (ES) Switch
is in the ON position. If you want all outlets to be always-on, set
this switch to the OFF position.
3 Plug secondary devices, such as a Blu-ray or DVD player, A/V
receiver, or CD player into the Master-controlled outlets on your
power manager
Note: Do not plug devices that you may want to use when the
device plugged into the Master outlet is turned o because
these devices will not receive power.
4 Plug devices that need constant power, such as a DVR/PVR or
devices you want to use when the device plugged into the
Master outlet is turned o, into the Always-on outlets.
5 Connect the incoming coaxial cable source (such as the cable
jack on the wall or incoming satellite line) to the coaxial jack
marked IN on the Power Manager.
6 Connect another coaxial cable to the cable OUT jack on your
power manager and to the cable IN jack on the TV (when not
using a cable or satellite box) or to the cable IN jack on the cable
or satellite or TV (if you do not have a cable/satellite box).
7 After all devices have been properly plugged into the Power
Manager and powered on, when you power the primary device
that is plugged into the Master outlet on and o, the secondary
devices that are plugged into the Master-controlled outlets will
automatically power on and o. Devices that are plugged into
the Always-on outlets will not be controlled by the primary
device, and must be powered on and o separately as desired.
Note: Should the Master-controlled outlets not power on and o
as described when the primary device plugged into the Master
outlet is powered on and o, it is possible that the primary
device draws too much current while in the OFF or STANDBY
mode. In the event this should occur with your equipment, try
plugging a dierent primary device into the Master outlet.
Specifications
• Load rating: 15 amps
• Line voltage: 125V AC @ 60 Hz
• Surge protection: 3 lines (L-N / L-G / N-G)
• Maximum surge current: 165,000 amps
• Maximum energy dissipation: 3,150 joules
• Clamping voltage: L-N / L-G / N-G = 400 volts
• EMI/RFI noise ltering: Up to 58 dB
• Standby power consumption: 0.99 watts
• UL-1449 certied
Safety precautions
• RISK OF ELECTRIC SHOCK–Use only in dry locations and only
indoors.
• DO NOT plug into another relocatable power tap.
• DO NOT daisy chain surge protectors.
• DO NOT use with any aquarium equipment.
• DO NOT use if correctly grounded outlets are not available.
• DO NOT install this device if there is not at least 30 feet
(10 meters) or more of wire between the electrical outlet and
electrical service panel.
One-year limited product warranty
See included warranty sheet or visit www.rocketshproducts.com
Contact Rocketsh
For customer support, call 1-800-620-2790 (U.S. and Canada) or
01-800-926-3010 (Mexico)
ROCKETFISH is a registered trademark of BBY Solutions, Inc. Registered in
some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield,
MN 55423 U.S.A.
©2013 BBY Solutions, Inc. All Rights Reserved.
V3 ENGLISH 13-0608
Loading...