RocketFish RF-HTS105 User Manual

Congratulations on your purchase of this Rocketsh Power Manager
with surge protection and noise ltering.
Your power manager:

• Reduces energy consumption to save environmental resources
and lower your electric bill

• Provides surge protection for sensitive electronic devices

• Incorporates noise ltering to provide “clean” power that will
maximize the life-span of your devices

7-outlet Power Manager with Surge

Protection and Noise Filtering

RF-HTS105

QUICK SETUP GUIDE

Features

1 Coaxial cable surge protection – protects your incoming coaxial

cable line from surges and spikes.

2 One master outlet – controls power to the four

master-controlled outlets.

3 Four master-controlled outlets – automatically shut down to

conserve energy when the device plugged into the master outlet
is turned o.

4 Two always-on outlets – provide continuous power regardless

of Master/Master-controlled outlets state.

5 Main power switch/circuit breaker – controls power to all AC

outlets on the Power Manager, and allows the unit to be reset in
the event of a circuit overload (after the overload condition has
been resolved).

6 Protected LED indicator – lights when the surge protection

feature is working properly. If this LED does not light or goes out,
the surge protection feature has reached full capacity and can no
longer absorb additional surges and spikes. The power manager
should be replaced if this light goes out.

7 Grounded LED indicator – lights when a properly grounded AC

outlet is detected. If this LED does not light, we recommend that
you contact a certied, licensed electrician to inspect your wiring.

8 5 ft (1.5 m) Soft-Flex™ power cord with right-angle/o-set

plug – enables placement of the Power Manager in the desired

location, furniture to be placed as close as possible to the wall
and will not block the second AC outlet.

• 2,100 joules surge protection – protects your equipment from
damaging power surges and spikes.

• 47 dB EMI/RFI noise ltering – ensures that your equipment
receives only clean power for maximum performance.

• Audible alarm – Sounds when the surge protection feature has
reached full capacity and can no longer absorb surges and spikes.
The power manager should be replaced if this alarm sounds.

• Power cord labels – attach these labels to your power cords
(near the plug end) to help identify which cord is attached to
which device in the event that one should need to be unplugged
for any reason. The labels are pre-printed for convenience, and
the blank labels can be customized for unique devices.

Operating instructions

1 Plug the power cord of the Rocketsh Power Manager into a

standard 120V AC outlet. If the LEDs do not light up, press the
main power switch/circuit breaker on the front of the unit.

2 Plug the power cord of your primary home theater device, such

as a TV, into the Master outlet of the Power Manager. When this
device is powered o or goes into a SLEEP or STANDBY mode,
power to the devices plugged into the Master-controlled outlets
will automatically be shut o, saving energy by preventing them
from drawing any standby current.

3 Plug the power cords of your secondary devices, such as a

Blu-ray/DVD player, A/V receiver, CD player, etc., into the
Master-controlled outlets of the Power Manager.

NOTE: Do not plug any device into a Master-controlled outlet
that you wish to use while the power of the primary device
plugged into the Master outlet is powered o, as these outlets
only provide power to the connected devices while the primary
device is powered on.

4 Plug the power cords of any devices that require constant power,

such as a DVR/PVR, or devices that you wish to use while the
primary device is powered o, into the Always-on outlets of the
Power Manager.

5 Connect the incoming coaxial cable source (i.e., the cable jack on

the wall or incoming satellite line) to the coaxial jack marked IN
on the Power Manager.

6 Connect a separate coaxial cable from the coaxial jack marked

OUT on the Power Manager to the coaxial input jack of the
cable/satellite set-top box.

7 After all devices have been properly plugged into the Power

Manager and powered on, when you power the primary device
that is plugged into the Master outlet on and o, the secondary
devices that are plugged into the Master-controlled outlets will
automatically power on and o. Devices that are plugged into
the Always-on outlets will not be controlled by the primary
device, and must be powered on and o separately as desired.

NOTE: Should the Master-controlled outlets not power on and o
as described when the primary device plugged into the Master
outlet is powered on and o, it is possible that the primary
device draws too much current while in the OFF or STANDBY
mode. In the event this should occur with your equipment, try
plugging a dierent primary device into the Master outlet.

Safety precautions

• RISK OF ELECTRIC SHOCK–Use only in dry locations and only
indoors.

• DO NOT plug into another relocatable power tap.

• DO NOT “daisy chain” surge protectors.

• DO NOT use with any aquarium equipment.

• DO NOT use if correctly grounded outlets are not available.

• DO NOT install this device if there is not at least 30 feet
(10 meters) or more of wire between the electrical outlet and
electrical service panel.

Connected equipment limited lifetime warranty: up to
$200,000 equipment coverage

One-year limited product warranty

See included warranty sheet, visit www.rocketshproducts.com or
call 800-620-2790 for additional connected equipment and
product warranty information or for customer service.

© 2011 BBY Solutions, Inc., All Rights Reserved.
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richfield, MN USA 55423-3645
ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and
brand names are trademarks of their respective owners.

Specications

• Load rating: 15 amps

• Line voltage: 125V AC @ 60 Hz

• Surge protection: 3 lines (L-N / L-G / N-G)

• Maximum surge current: 105,000 amps

• Maximum energy dissipation: 2,100 joules

• Clamping voltage: L-N / L-G / N-G = 400 volts

• EMI/RFI noise ltering: Up to 47 dB

• Standby power consumption: 0.98 watts

• UL-1449 certied

ENGLISH 10-1214