Rinnai rhfe-556ftp Operation Manual

How to use your
Heater
Space
Rinnai
Energysaver
RHFE456FTR
Customer
Installer
tipage 21
Guarantee Layout of appliance Features
Safety Points Operation
Adjusting Temperature
Economy Mode Child-Lock Humidifier Clock ON/OFF Timers
Override Remote Control
This appliance shall be installed in accordance
with:
l Manufacturer’s Instructions l Local Authority Building Codes l NZS 5261 Installation Code for Gas Burning
Equipment
l Any other relevant Statutory Regulation
This appliance must be installed, serviced and
removed by an authorised person.
DEAR CUSTOMER
THANK YOU FOR PURCHASING THIS RINNAI APPLIANCE. WE ARE PLEASED TO ADVISE THAT
RINNAI PRODUCTS ARE NOW COVERED BY A 2 YEAR.
GUARANTEE: FREE PARTS AND
LABOUR FOR THE FIRST YEAR AND PARTS ONLY FOR THE SECOND YEAR.
- THIS GUARANTEE IS IN ADDITION TO ANY GUARANTEES WHICH
CONSUMERS MAY HAVE UNDER THE CONSUMER GUARANTEES ACT -
SHOULD YOU HAVE ANY QUERIES REGARDING THIS GUARANTEE PLEASE CONTACT YOUR LOCAL RINNAI AGENT.
Please record below the following information for your own records. Your Retailer:
Address:
Phone: Date of Purchase: Your Installer:
Installer’s Liience No. Address:
Phone: Date of Installation:
-l-
I
REMOTE CONTROL BRACKET
Built into the warm air discharge duct. Humidifies the warm
BOlTOM TRIM
Pulls off to allow
filling of humidifier
I
CONTROL PANEL
I
rvith
Concealed panel c
clock, room and pre-set terf --I selection.
lperarure
Time, temc
berature
and appliai .__ _.. .
w-.~? errr)r
codes are shown
here.
ON/OFF SWITCH
1
1 tray.
I
AIR FILTER
ELECTRICAL CORD
1 Helps to protect the
EXHAUST OUTLET
-2-
I
0
I
Indicates Child Proof
Indicates that Timer 1 or Timer 2 has been
Shows either the time of day,
Indicates that the appliance
is turned ON and
Indicates that the
Economy mode is
in
override function is
Indicates that clock or dual
i 1
Timer 2
Override
ky----1
Set l Room
c;niIa Low tconomy I imerl
I
/
\ c
\ /
\ I
7 r >
I
nnnnn
wwwww
\
\
/
1
Clock l Timer 1 l l Timer20 On l
OfI
1’
Filter
*ON-Q
InI
1 O/N/OiF 1
Locks all controls
Selects operating mode for Timer 1
Increases or decreases the
Main switch for turning ON/OFF.
Selects energy saving
Temporarily changes operation from ON toOFF or OFF to ON, until next
Selects clock and/or Timers for adjusting
or
I
P
I
Operates the heater
0
ON
a--
RiMai
cIlzz+
OFF
0,
A
FRONT
I
Increases or decreases
the temperature setting.
Simply open the back of the remote
control and replace Lithium battery.
TYPE: CR 2032
REVERSE
Power source
for operating
remote control.
Air for combustion is taken from outside the room and the flue products are exhausted outside, keeping the room air
clean.
Warm air flows from the bottom of the appliance through the louvres, assisting
in even heat distribution. An integral humidifier tray is built into the warm air discharge duct.
The function will automatically operate the appliance within one hour prior to the
programmed time of the Timer. This is designed to heat a room to the pm-set
temperature by the programmed time.
paw 16)
Only one touch of the ON/OFF switch is required to operate the heater.
(See paw 9)
The Dual Timer allows you to programme the appliance to come on for two separate
periods each day, usually one period in the morning, and one period in the evening. The built in Intelligent Mode brings the room temperature to the temperature you have selected, by the time programmed into the Timer.
The Dual Timer feature means that you can
“Set and Forget” your heater. It will turn itself ON and OFF at times you have programmed until you cancel the Timer program.
-5-
When the fan filter becomes covered with dust and the temperature inside the appliance rises, the filter indicator will flash. The filter should be vacuumed at
regular intervals to avoid unnecessary
strain on the appliance.
For the convenience of turning the heater ON or OFF, as well as adjusting the temperature up or down while at a short distance from the heater.
This is an energy saving feature designed to reduce the room temperature to
1°C
less than the preset temperature over a period of 30 minutes, and an additional 1°C after another 30 minutes.
1 hour
Ensures that the flow of warm air from the louvres is maintained at a comfortable volume during the warm-up period by a 8 step modulating convection fan, in conjunction with the thermostat, reducing cool draughts.
(See
page 11)
When the Child Proof lock is activated all controls other then the OFF switch will be locked. De-activating the lock releases the controls. If the lock is activated when the appliance is off, all functions will be locked.
(See page 11)
The micro computer records selected pre­set temperatures, the times programmed
into Timers as well as operating the
Economy and
Intelligent modes, to
maintain comfort levels.
-6-
Do not restrict the warm air discharge This appliance must not be used for any by placing articles in front of the heater.
purpose other than heating.
Do not spray aerosols whilst the heater is operating. Most aerosols contain butane
Flue guard is recommended where children may be able to touch the flue terminal.
Do not allow curtains or other flammable or combustible materials to come into contact with the heater.
.
Do not allow anyone to sit on or lean against the appliance.
materials must not be placed
where the heater could ignite them.
-7-
Keep flammable materials, trees, shrubs, etc, away from the flue terminal.
Filter should be cleaned at regular intervals. See Page 12.
A&
Clean with vacuum cleaner, weekly.
Do not place articles containing liquids on top of the heater. Liquids spilt on the controls may cause extensive dam
Do not allow anyone to post articles
through the louvres.
Young children should be supervised at all times. Hand or body contact with the
louvres should be avoided.
Do not allow young children or the infirm sleep directly in front of the heater.
to
-8-
n TO OPEN THE CONTROL PANEL
Lift lightly in the centre of the lid where there is a catch. The control panel lid will then drop backward to an angle.
I \
n TURNING ON
Press the ON/OFF button to operate the heater. The ON indicator will glow green.
After approximately 20 seconds the spark
generator will be heard before the burner ignites and the ON indicator glows red, indicating that the burner is alight. Warm air can be felt coming from the louvres 15 seconds later.
If the heater does r-108 ignite on initial use, this may be due to air ~e~ai~i~~ in the gas supply line. The spark generator will only continue for 15 seconds. After fhis It will be necessary to
2 press the QN/&FF button OFF, then ON again.
n TURNING OFF
Simply press the ON/OFF button to switch off the heater. The ON indicator will go out. The convection fan will continue to operate for several minutes after the burner has gone out in order to cool the appliance. Do not unplug
the appliance while the convection fan is running.
-9-
Loading...
+ 22 hidden pages