Remington XR1450 Instruction manual

Download

Page 1

HyperFlex Aqua

XR1430 XR1450 XR1470

£10,000 prize draw

EXTRA year guarantee

FREE rewards gallery

of purchase.

You must register within 28 days

Visit www.remington.co.uk/productregister

Page 2

Thank you for buying your new Remington® produc t. Please read these instructions carefully and keep them safe. Remove all packaging before use.

F IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE OR INJURY TO PERSONS: 1 This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the haz ards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years. 2 The adaptor contains a transformer. Do not cut oﬀ the adaptor to replace it with another plug, as this causes a haz ardous situation. 3 Do not leave the appliance unattended while plugged in. 4 Keep the power plug and cord away from heated surfaces. 5 Make sure the power plug and cord do not get wet. 6 Do not plug or unplug the appliance with wet hands. 7 Do not use the product with a damaged cord. A replacement adaptor can be obtained via our International Service Centres. 8 Do not twist or kink the cable, or wrap it round the appliance. 9 Charge, use and store the product at a temperature between 10°C and 35°C. 10 This appliance is not intended for commercial or salon use. 11 Suitable for use in a bath or shower. 12 Suitable for cleaning under an open water tap. 13 Do not reach for an appliance that has fallen into water. Unplug it immediately. 14 This appliance should be charged by approved safety isolating adaptors PA-0510(K) with the output capacity of 5.0Vdc; 1.0A.

Page 3

C KEY FEATURES

1 On/oﬀ switch 8 LED display (XR1470) 2 Head and cut ter assembly 9 Pop-up trimmer 3 Comfort Float cutters 10 Trimmer release button 4 Hairpocket 11 Charging pins 5 Antimicrobial head surrounds 12 Charging stand 6 Charging indicator light 13 Adaptor

& low battery indicator (XR1430) 14 Headguard 7 Fuel gauge (XR1450) 15 Cleaning brush

Page 4

C GETTING STARTED

It is recommended that you use your new shaver daily for up to four week s to allow time for your beard and skin to become accustomed to the new shaving system.

, CHARGING STAND

• Rotate open the charge stand fully to stand ﬁrmly on a ﬂat sur face while charging. For travel you can fold the stand around the shaver (see below).

, CHARGING YOUR SHAVER

• Ensure the appliance is turned oﬀ.

• Connect the charging stand to the adaptor and then to the mains.

• Place the shaver in the charging stand.

• Charge for at least 24 hours when using for the ﬁrst time.

• Allow 90 minutes for a full charge (XR1450 and XR1470) and 4 hours for XR1430.

• The charging indicator light (XR1430), fuel gauge (XR1450) or LCD display (XR1470) will indicate when the shaver is fully charged.

, XR1430: When charge is low, the top LED will illuminate a solid red light.

When charging the bottom LED will illuminate a solid green light. When fully charged both LEDs will be oﬀ.

, XR1450: The fuel gauge will display the amount of charge left when the

shaver is on. When charging, the LEDs blink in a clockwise rotation. When fully charged all LEDs will illuminate then turn oﬀ.

Page 5

, XR1470: When charge is low ‘Lo’ will appear on the screen and will ﬂash until

the shaver is plugged in to charge. When charging, the LEDs blink in a clockwise rotation. When fully charged the indicator will ﬂash 60 for 5 minutes and then the display will shut oﬀ.

• To preserve the life of your bat teries, let them run out every 6 months then recharge for 24 hours.

• The appliance adapts automatically to a mains voltage bet ween 100V and 240 V.

F INSTRUCTIONS FOR USE

, SHAVING , Note: This shaver is for cordless use only.

• Make sure your shaver is properly charged.

• Switch the shaver on.

• Stretch the skin with your free hand so the hairs stand upright.

• Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and make them vulnerable to breakage).

• Use short, circular strokes.

, SHAVING WITH SHAVING GEL

• Follow the same instructions as dr y shaving if using shaving gel.

, CAUTION

• After use with shaving gel, please rinse the head and cutters under warm water to clean away any excess gel and debris.

, TRIMMING

• Push the trimmer button to release the detail trimmer.

• Hold the trimmer at a right angle to your sk in.

• Place the trimmer at desired trim line for a quick, easy, professional trim.

• To retract the trimmer, push down until it lock s into position.

, TRAVEL LOCK FEATURE

• Model XR1470 is equipped with a Travel Lock feature, intended to prevent the shaver from turning on and discharging accidentally while packed in luggage.

, To Set the Travel Lock:

• Press and hold the on switch for 3 seconds. The shaver will turn on, then will shut oﬀ after the 3 seconds. The LED display will ﬂash ﬁve times to indicate the lock is set.

Page 6

• While the travel lock is set, if the on switch is pressed, the LED display will ﬂash three times to indicate the shaver is in travel lock mode.

, To Unlock the Travel Lock:

• Press and hold the on switch for 3 seconds. The LED display will ﬂash three times while the button is being held and then the shaver will turn on.

, Turbo feature (XR1470 only)

• The XR1470 comes with a Turbo feature to shave thick stubble. Press the on/oﬀ switch once to operate the shaver at normal speed. Press the on/oﬀ switch a second time to operate the shaver in Turbo mode. When the Turbo feature is ac tivated the LED display will cycle around.

• To deactivate press the on oﬀ switch once to turn the shaver oﬀ.

E TIPS FOR BEST RESULTS

• Use moderate to slow stroking movements. The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.

• DO NOT press hard against the skin in order to avoid damage to the rotar y heads.

C CARE FOR YOUR SHAVER

• Care for your appliance to ensure a long lasting per formance.

• We recommend you clean your product after each use.

• The easiest and most hygienic way to clean the appliance is by rinsing the appliance head after use with warm water.

, CLEANING

• Pull the rotar y shave face oﬀ the hair pocket (Fig. 1 and 2).

• Tap out excess hair shavings from the hair pocket (Fig. 3). Hair clippings can also be washed out of the hair pocket and or shave face by rinsing these under the tap.

• Once dry, snap the shave face back onto the hair pocket (Fig. 4).

Page 7

, CLEANING TRIMMER

• Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.

• Replacement parts and accessories are available to buy at http://www.remington.co.uk/ parts-accessories

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.

• The appliance must be disconnected from the supply mains when removing the bat tery.

• Run the shaver until the motor stops.

• Remove the head from the shaver (pull the head up and oﬀ ).

• Using a small screwdriver, pry the ‘collar’ oﬀ of the top of the handle.

• Using a small screwdriver, pry the front cover from the body.

• Remove three screws located on front of shaver.

• Using a small screw driver, pry up the newly unsecured inner housing to expose the batter y.

• Pry battery free from circuit board.

• Dispose of battery properly.

H ENVIRONMENTAL PROTECTION

To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled.

E SERVICE AND GUARANTEE

Defects aﬀecting product functionality appearing within the guarantee period will be corrected by replacement or repair at our option provided the product is used and maintained in accordance with the instructions. Your statutory rights are not aﬀected. Consumables are excluded. Defects from repair by an unauthorized dealer are not covered. If you call the Service Centre, please have the Model No. to hand, as we won’t be able to help you without it. The Model No. can be found on the rating plate of the appliance. Replacement parts and accessories are available to buy at www.remington.co.uk/parts-accessories

Page 8

E SERVICE CENTRE

United Kingdom

G Tel 0800 212 438 (free call mainland UK) G +44 161 947 3111 (call outside the UK)

Spectrum Brands (UK) Ltd Fir Street, Failsworth, Manchester M35 0HS, UK www.remington.co.uk

Ireland

G Tel 142 951 40 Remington Consumer Products, Unit B12, Ballymount Corporate Park, Ballymount, Dublin 12. www.remington.co.uk

I REGISTER ONLINE FOR

£10,000 prize draw, EXTRA year guarantee, FREE rewards gallery.

Visit www.remington.co.uk/productregister. You must register within 28 days of purchase.

Model No. XR1430 XR1450 XR1470

16/UK/ XR1430 XR1450 XR1470 T22-0004077 Version 03 /16 Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries. Spectrum Brands (UK) Ltd Fir Street, Failsworth, Manchester M35 0HS www.remington.co.uk © 2016 Spectrum Brands, Inc.