Remington Smooth & Silky WDF4820AU, DD90 SERIES Use & Care Manual

17 8 7 8
CLEANING & MAINTENANCE
CARE FOR YOUR SHAVER
To ensure long lasting performance of your shaver, clean the head assembly regularly. The easiest and the most hygienic way to clean the shaver is by rinsing the shaving head after use with warm water. Always keep the protective headguard on the shaving head when the shaver is not in use.
1. Ensure the shaver is turned off.
2. Press the release buttons to open the shaver head.
3. Blow on the foils to remove any loose debris.
4. Brush or rinse the accumulated hair from the main body of the shaver, shaving head and cutter assembly.
5. Leave the head assembly open to let the shaver dry completely.
6. Return the shaving head to its original position and snap in place.
NOTE:
• Ensure that the shaver is turned off when cleaning.
• Do not clean the shaving foils with the brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and cutters
heads.
REPLACING THE FOILS & CUTTERS
Signs that your foils and cutters need replacing:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel
your cutter pulling on your hair.
Wear: You may notice that the cutters have worn through the foils.
To ensure the continued highest quality performance from your shaver, we recommend that foils and cutters are replaced every 6 months.
Money Back Offer - Australia/New Zealand Only
If within 30 days you are not fully satisfied with your Remington® shaver, just return the shaver with this completed coupon and a copy of your Australian/New Zealand purchase receipt to Remington®. In return, we will send you a cheque for the full purchase price of the shaver. Please allow 6-8 weeks for your cheque to arrive.
Name:
_________________________________________________
Address:_______________________________________________
City:_____________________ State:________ Postcode: ________
2 YEAR WARRANTY WDF4820AU / WDF4835AU
USE & CARE
MANUAL
PLEASE READ PRIOR TO USE
RECHARGEABLE SHAVER
9 10
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010;
CGA means the New Zealand Consumer Guarantees Act 1993;
Goods means the product or equipment which was accompanied by this warranty and
purchased in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited, as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia or in New Zealand; and
You means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and remedies in respect of the Goods which the consumer has under either the Australian Consumer Law or the CGA. The original purchaser of the Goods is provided with the following Warranty subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the period of two (2) years from the date of purchase (Warranty Period). If the Goods prove defective within the Warranty Period by reason of improper workmanship or material, we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This Warranty does not apply should the defect in or failure of the Goods be attributable to misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of the user. As far as the law permits, the manufacturer does not accept liability for any direct or consequential loss, damage or other expense caused by or arising out of any failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods are included under this Warranty only where there is a defect in workmanship or materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the property of the manufacturer. In the event of the Goods being replaced during the Warranty Period, the warranty on the replacement Goods will expire on the same date as for the Warranty Period on the original Goods which are replaced.
8. In order to claim under the warranty granted under clause 3 you must: (a) Retain this warranty with your receipt/proof of purchase; and (b) Return the Goods to us at the relevant address belo w or to the Supplier by prepaid
freight within the Warranty Period accompanied with (i) the legible and unmodified original proof of purchase, which clearly indicates the name and address of the Supplier, the date and place of purchase, the product name or other product serial number and (ii) this warranty.
9. This warranty is immediately void if: (a) Any serial number or appliance plate is removed or defaced; (b) The Goods have been ser viced or otherwise repaired by a person not authorised to
do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any industrial or commercial use of the Goods. The Goods must be connected to the electrical voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty or transport of the Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Chifley Business Park 1 Chifley Drive Mentone, VIC 3194 Australia Customer service in Australia: 1800 623 118 E-mail: consumer.enquiry@remington-products.com.au Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
Building C, Ground Floor 600 Great South Road, Greenlane, Auckland 1051 New Zealand Customer service in New Zealand: 0800 736 776 E-mail: info@remington.co.nz
Website: www.remington-products.com.au
REMINGTON SERVICE HOTLINE
Australia 1800 623 118 (toll free)
New Zealand 0800 736 776 (toll free)
AUTHORISED REPAIR CENTRES
Visit www.remington-products.com.au for Authorised repair centre details. ® Registered Trade Mark of Spectrum Brands Inc., or one of its subsidiaries © 2012 SBI Rev. 05/12 Part No. T22-0000279
TO REPLACE THE FOIL
1. Ensure the shaver is switched off.
2. Remove the shaver head.
3. Gently push the small plastic tabs area at either end of the foil carrier. The foil carrier should then easily detach from the shaving head.
4. To reassemble, snap the new foil carrier into position.
5. Attach the shaving head.
CAUTION
• Onlyholdtheplastictopreventdamagetothe foil.
• Donotpressonthefoilwhenreplacing.
TO REPLACE THE CUTTERS
1. Ensure the shaver is switched off and open the shaving head.
2. To remove cutter, grasp cutter between thumb and forefinger and pull upward.
3. To reassemble cutter, place cutter onto oscillator tip. Gently push down clicking into position.
Remington strongly recommends that an approved Safety Switch (Residual current device) be installed to protect all bathroom power outlets. Ask an electrical contractor for advice.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
new foil
tabs
2 3 4 5 6
ABOUT YOUR SHAVER – WHICH SHAVER IS YOURS?
SPECIFICATIONS WDF4820AU WDF4835AU
Power System Cordless (Rechargeable) Cordless (Rechargeable)
Initial Charge Time 20 Hours 20 Hours
Full Charge Time 20 Hours 20 Hours
Cordless Shave Time 30 Minutes 30 Minutes
Indicators Charging Charging
Foil Coating Nickel
Gold Titanium, 80% smoother, 300% stronger*
Massaging Strip Yes Yes, Aloe Vera infused
Voltage Type Single Single
Spare Part SPW480AU SPW-490AU
Power System: Cordless – shaver can only be used without the power cord.
Charging Indicator: Light that glows when the shaver is being charged.
Voltage Type: Single Voltage – shaver can only be used with an outlet voltage
of 220-240V.
INSTRUCTIONS FOR CHARGING
Always ensure that your hands, trimmer and charge stand are dry before charging.
BeforeusingyourREMINGTON®shaverforthefirst time,chargefor20hours.
For subsequent uses, charge for 20 hours before use. The charging indicator light on your charge stand will light up to indicate that your shaver is charging.
Onefullchargeallows30minutesofcordless usagetime.
Use product until the battery is low. This is indicated by the shaver running distinctly slower.
Your shaver cannot be overcharged, however, if the product is not going to be used for an extended time period (2-3 months), unplug it from the outlet and store. Fully recharge your shaver for 20 hours when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for 20 hours.
CHARGING CAUTIONS
• Do not attach the power adaptor to the outlet with wet hands.
• Always charge the shaver in a cool, dry place.
• Do not charge the shaver in close proximity to water.
WDF4820AU / WDF4835AU
Use & Care Instruction Manual
Thank you for purchasing your Remington® Shaver. The model you have chosen can be used in or out of the shower and is designed to provide a gentle, close shave.
HOW TO USE
Your shaver is suitable for legs, underarms and the bikini area. It can be used dry or in the shower but only if it is unplugged.
FOR EVERYDAY SHAVING
1. Remove protective cap.
2. Turn the shaver on.
3. Hold the shaver at a right angle to your skin and move the shaver against the direction of the hair growth.
4. After shaving, turn shaver off.
NOTE:Beforedryshaving,makesurethattheareais clean,dryandfreefrom
creams or oils.
If you have not shaved for a while, use the flexible trimmer before shaving. This will help you achieve a more effective shaving result:
1. Turn shaver on.
2. Hold the shaver with the trimmer facing your leg and slightly tilted towards you (approximately at a 45º angle).
3. Move the trimmer slowly against the direction of the hair growth.
4. After shaving, turn shaver off.
TRIMMING AND SHAPING
1. Attach the bikini trimmer headguard.
2. Turn the shaver on.
3. Hold the shaver at a right angle to your skin and press down gently.
4. Edge and shape the area as desired.
5. After shaving, turn shaver off.
FOR BEST SHAVING PERFORMANCE
We recommend that you use your new shaver daily for two or three weeks to allow time to find the optimum shaving methods for your particular type of hair growth patterns.
CAUTION
If your skin is easily irritated by shaving, or you suffer from skin allergies, you should test a section of your arm or leg before using the shaver.
NOTE:
• TheshaverisNOTsuitableforuseinthebath.
• Rinse only with cool or warm water, not hot water. Do not rinse with water
hotter than 70°C.
• Do not completely submerge the shaver in water.
1. Shaving head
2. Head release button
3. Flexible outer foils
4. Massaging strip
(Aloe Vera infused - WDF4835AU only)
5. Flexible trimmer with comfort tips
6. On/Off switch
7. Charge stand
8. Charging indicator light
9. Bikini trimmer headguard
Also includes:
• Cleaning brush
• Storage pouch
KEY PARTS
9
1
3
6
7
2
4
8
5
32
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
To reduce the risk of electric shock:
•
Do not place or store this appliance where it can fall or be pulled into a tub or sink.
• Except when charging, always unplug this appliance from the electrical outlet immediately after using.
• Unplug this appliance before cleaning it.
• Do not use an extension cord or a voltage converter with
this appliance.
• Do not use while bathing or in the shower if it is plugged in.
• This appliance is for household use only.
• This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• Use this appliance only for its intended use as described in this manual.
• Do not use attachments not recommended by Remington.
• Keep the cord away from heated surfaces.
• Never operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water.
• Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
• Plug charger directly into outlet - do not use an extension cord.
• Unplug charger before plugging or unplugging appliance.
• Do not store it in temperatures exceeding 60°C (140°F).
• Do not plug or unplug this appliance when your hands
are wet.
• Do not wrap the cord around the appliance or charge stand.
• Always attach the plug to the appliance, then to the outlet.
Todisconnect,turnallcontrolstoOFF,thenremoveplug
from outlet.
• Detach removable power cords from appliances for storage.
• Never drop or insert any object into any of the appliance’s
openings.
• The power unit is intended to be correctly oriented in a vertical or floor mount position.
• Do not use this appliance with damaged or broken heads or cutters, as injury may occur.
SAVE THESE INSTRUCTIONS
*Compared to standard uncoated nickel foils
Loading...