Remcor TJ90 Installation Manual

RemcorIncorporate

d

500 Regency Drive
Glendale Heights, IL 60139
Telephone [phone]
Facsimile [phone]

FOR

KIT 02317

For installing Ice-O-Matic Model GC300, 550 Series Ice Makers on Remcor Model TJ90 series Ice Dispensers.

1. Seal ice maker to top of dispenser as follows:
A. Run a bead of RTV on the dispenser cover around the outline of the ice maker and inside edge of cov-

er opening.
B. Set ice maker onto cover and position as shown.
C. Wipe away excess RTV.

2. Fasten brackets as shown. Drill holes and install sheet metal screws provided into ice maker cabinet and
dispenser cover. Screws must not interfere with ice maker components.

3. Follow the manufacturer’s instructions to complete the installation of the ice maker.

/

7

23

8

ICE O MATIC

GC300 SERIES

22

POSITION ICE-MAKER

ON DISPENSER COVER,

FLUSH WITH BACK

EDGE OF COVER

APPLY RTV AROUND IN-

SIDE OF ICEMAKER OUT-

LINE ON DISPENSER

COVER TO FORM A SEAL

MOUNT BRACKETS TO
ICEMAKER AS SHOWN

DRILLING HOLES MUST

NOT INTERFERE WITH

ICEMAKER COMPONENTS

FIGURE 1. INSTALLATION INSTRUCTIONS KIT 02317

1

91854