Rane DANTE-X Installation Guide
DANTEx
Installation Guide v1.2
Introduction & Support
Thanks for purchasing the Rane DANTEx. The DANTEx is an optional plug-in card for the Rane Terminal 1010x
which allows system designers to integrate a Terminal 1010x processor with Dante-equipped microphones,
amplifiers, breakout boxes, mixing consoles and other supported devices. It provides 32 inputs and 32 outputs of
Dante digital audio with supported sample rates of 44.1 kHz, 48 kHz, 88.2 kHz and 96 kHz. Built-in sample rate
conversion (SRC) converts the Dante sample rate to the fixed 48 kHz sample rate required by the Terminal 1010x.
The Dante interface is managed using Audinate’s Dante Controller software. Dante Controller is a free software
application that enables the user to route audio and configure devices on a Dante network. For additional
information, downloads and support, please visit audinate.com
For additional product support or system applications, design examples and related HAL information, please visit
ranecommercial.com/support
If you need additional assistance, please contact our HAL technical agents at halogen@rane.com
Installation
Important: Before installing the DANTEx card, remove the power cable from Terminal 1010x and wait at least 15
seconds.
To install the DANTEx card in the Terminal 1010x:
Step 1:
Use a screwdriver to remove the
two screws from the Expansion
Card cover plate on the back of
Terminal 1010x. Set the plate aside.
Your DANTEx card is now installed!
Step 2:
IMPORTANT: Make sure that the
DANTEx card is aligned into the
guide rails inside the empty slot, not
above or below the rails. Improper
inserting of the card above or below
the guide rails can result in damage
to the card, unit, or both.
Once aligned, carefully slide the
DANTEx card into the empty slot
along the guide rails inside until you
hear it "snap" into place.
Step 3:
Use a screwdriver to secure the
DANTEx card to Terminal 1010x
using the provided screws. Be
careful not to over-tighten the
screws.
Trademarks & Licenses
Rane is a trademark of inMusic Brands, Inc., registered in the U.S. and other countries.
All other product names, company names, trademarks, or trade names are those of their respective owners.
ranecommercial.com
Loading...