Radio Shack Microphone User Manual
Pro Unidirectional Highball Microphone
OWNER’S MANUAL — Please read before using this equipment.
Your RadioShack Pro Unidirectional Highball Microphone provides the
quality performance you need for your PA or recording system. Its unidirectional pickup pattern provides increased tonal sensitivity while reducing unwanted sounds and feedback.
Its other features include:
Wire Mesh Windscreen
ON/OFF Switch
— for convenient control of the microphone
Choice of 600-ohm or 50-k ohm Impedance
— cuts down on wind noise and breath pops
— lets you match your
microphone to a wide range of equipment
Microphone Stand Clamp
— holds the microphone and lets you place
the microphone on a microphone stand (not supplied)
Carrying Pouch
— lets you carry your microphone and accessories in
a convenient pouch
CONNECTION
Connect the supplied microphone cable’s XLR connector to the pins
on the bottom of the microphone, plug the microphone cab le’s 1/4-inch
(6.35 mm) plug to the audio equipment’s MIC jack.
OPERATION
ON/OFF
volume control. To turn on the microphone, slide the
reveal ON; to turn the microphone off, slide the switch to reveal
lets you control the microphone without changing the amplifier
ON/OFF
switch to
.
OFF
CHANGING IMPEDANCE
Your microphone is preset to 600 ohms impedance. You can change
its impedance from 600 ohms to 50 k ohms to match your audio equipment’s impedance requirement.
USING THE MICROPHONE STAND CLAMP
The supplied microphone stand clamp lets you place your microphone
on a microphone stand (not supplied). Screw the holder onto the top of
a microphone stand. Then slide the microphone into the larger end o f
the holder until it is secure.
FREQUENCY RESPONSE CURVE
Relative Response in dB
Frequency in kHz
SPECIFICATIONS
Type ..................................................................................................... Dynamic
Polar pattern ................................................................................ Unidirectional
Impedance .......................................................... High 50k ohms (@ 1,000 Hz)
Low 600 ohms (@ 1,000 Hz)
Sensitivity ...................................................................................... High: –57 dB
Low: –76 dB
Frequency Response .................................................................. 70–13,000 Hz
Connector .............................................................................. 3-Pin XLR (Male)
Microphone Body Material .......................................................................... Zinc
Accessories .............................................................................. Carrying Pouch
Microphone Stand Clamp
Cable 16 Feet 7 Inches (5 meters) (diameter 6mm) with XLR connector at
one end
1
/4 Inch (6.35 mm) plug at the other end
Follow these steps to change impedance.
1. Use a Phillips screwdriver to remove the screw on the lower end
of the microphone. Then using a pair of needle nose pli ers, carefully pull out the 3-pin connector. Be careful not to break the wires.
2. Carefully pull the low impedance red wire terminal out from pin
number 2 (marked beside the pin on the bottom).
3. Connect the high impedance yellow wire terminal to pin number 2.
4. Matching the terminal base’s plastic tab with the notch on the
microphone bottom, carefully reinsert the wires and terminal base
into the microphone body until the screw hole in the base aligns
with the screw hole in the microphone body. Replace the screw
and tighten it.
2001 RadioShack Corporation.
©
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
All Rights Reserved.
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack companyowned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED
HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE
OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT,
SPECIAL, INCIDENT AL, OR CONSEQ UENTIAL DAMAGE S, EVEN IF RadioShack HAS B EEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to
you.
In the event of a product defect during the warranty period, take the product and the RadioShack
sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase
price. All replaced parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the performance of
warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the
expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,
accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs
of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
We Service What We Sell
12/99
RadioShack Corporation
Fort Worth, Texas 76102
33-3027
04A01
Printed in Taiwan
Loading...