Radio Shack 43-3106 User Manual

www.radioshack.com

2-Channel FM Wireless

Intercom

OWNER’S MANUAL — Please read before using this equipment.

WARNING: To reduce the

risk of fire or shock hazard, do not exposethis productto rain or moisture.

CAUTION

RISK OF ELECTRIC

SHOCK. DO NOT

OPEN.

CAUTION: TO REDUCE

THERISKOFELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

This symbol is intended to alert you to the presence of uninsulated dangerous voltage within the product’s enclosure that might be of sufficient magnitude to constitute a risk of electric shock. Do not open the product’scase

This symbol is intended to inform you that important operating and

maintenance instructionsareincluded in the literature accompanying this product.

43-3106

TX (Transmit Indicator)

CHANNEL A/B

TALK

LOCK

Your RadioShack 2-Channel FM Wireless Intercom is convenientand easy to use.Installationis quick andsimple. Simply plug each of the two supplied stationsinto a standard three-wire AC outlet, and you are ready to send and receive callsor monitor an area where a station is installed. Each of your intercom’s stations has the following features:

Adjustable Volume Control — allows you to alter the volume to suit the noise levelin the room.

Lockable Talk Bar — allows you to talk to or monitor a room hands-free.

Call Tone — alerts other stations before you start talking. Desk or Wall Mounting Capabilities — provide easy,

convenient placement of stations. Your intercom is ETL listed and meets all applicable FCC

standards.

OFF/ VOLUME

CALL

IMPORTANT

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

— Warning

 — Caution Ó — Hint

— Important Ô — Note

RadioShackandRadioShack.com

are trademarks used by

RadioShack Corporation.

INSTALLATION

You caninstall the stations almost anywhere there is a standard AC outlet. Simply plug each station into an outlet andplaceitdirectlyonadesk,shelf,tableoronawall.

MOUNTING

To mounta station on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the stations.

1. Select a location for the station. Mark the mounting screw locations on the wall 2 inches (50.8 mm) apart, one abovethe other.

2. Drill holes at the marked locations.

IMPORTANT

Stations can transmit up to 300 feet and between buildings as long as they are connectedto the same power line transformer.

Ô NOTE Ô

Make sure you install the stations at least 10 feet away from each other. Placing the stations too close together produces feedback and creates a squealing sound.

3. Thread a screw into each hole allowing the screw heads to extend about

4. Alignthekeyholeslotsonthebottomofthestationwith thescrewheadsinthewall.Slidethestationdownonto thescrewstosecureit.

/16 inch (4.3 mm) from the wall.

OPERATION

SETTING THE CHANNEL

Each station has two channels, so you can select which station you want to communicate with. You can also use a station to monitor sounds near another station.

For example, you could set a station installedin the kitchen to ChannelA and a station installed in the family room to Channel B. Using the station installed in the kitchen, you can communicate with thestation in the family room by setting the channel selector to B.

Set the channel selector on each station as follows:

• If you want all the stations to communicate with each other at the same time, set all stations to the same channel.

• If you want to use a station to communicate with only one of the other stations, set only those stations to the same channel.

+ 2 hidden pages