Quick Fuel Technology 30-7025 – 2-PORT PLUS+ REGULATOR User Manual

Loading...

30-7025 – 2-PORT PLUS+ REGULATOR

INSTALLATION AND ADJUSTING INSTRUCTIONS:

Your Two Port Regulator has been pre-set to approximately 6 PSI. This is a good starting point. Pressure should always be set with the engine idling. Failure to do this can result in damage to the regulator's internals due to excessive overadjustment. Turning the adjustment stud clockwise will increase pressure, counter clockwise will decrease pressure. The regulator pressure is adjustable between 5 and 8 PSI.

QFT™ recommends mounting the regulator as close as possible to the carburetor.

The hole in the top of the cap is a vent and should be left open and kept clear to assure proper regulator function. Remember, after installation, check for any leaks. Your safety depends on it.

Figure 1

SERVICE PARTS AND ACCESSORIES

 

ITEM

 

 

PART NUMBER

 

 

 

 

 

 

#8 AN O-ring to #6 AN, red anodized (Outlet Port)

 

19-106-2

 

 

#8 AN O-ring to #6 AN, black anodized (Outlet Port)

 

 

19-106-2BLK

 

 

#8 AN O-ring to #8 AN, red anodized (Outlet Port)

 

19-108-2

 

 

#8 AN O-ring to #8 AN, black anodized (Outlet Port)

 

 

19-108-2BLK

 

 

#10 AN O-ring to #8 AN male, black anodized (Inlet Port)

 

19-1008

 

 

#10 AN O-ring to #10 AN male, black anodized (Inlet Port)

 

19-1010

 

For warranty information, please see our website at www.quickfueltechnology.com.

For further questions, please contact our technical department at 1-270-793-0900.

99-30-7025

Revision Date: 12-17-13