Quick Fuel Technology 30-7025 User Manual

ITEM

PART NUMBER

#8 AN O-ring to #6 AN, red anodized (Outlet Port)

19-106-2

#8 AN O-ring to #6 AN, black anodized (Outlet Port)

19-106-2BLK

#8 AN O-ring to #8 AN, red anodized (Outlet Port)

19-108-2

#8 AN O-ring to #8 AN, black anodized (Outlet Port)

19-108-2BLK

#10 AN O-ring to #8 AN male, black anodized (Inlet Port)

19-1008

#10 AN O-ring to #10 AN male, black anodized (Inlet Port)

19-1010

30-7025 – 2-PORT PLUS+ REGULATOR

INSTALLATION AND ADJUSTING INSTRUCTIONS:

Your Two Port Regulator has been pre-set to approximately 6 PSI. This is a good starting point. Pressure should always
be set with the engine idling. Failure to do this can result in damage to the regulator's internals due to excessive over­adjustment. Turning the adjustment stud clockwise will increase pressure, counter clockwise will decrease pressure. The
regulator pressure is adjustable between 5 and 8 PSI.

QFT™ recommends mounting the regulator as close as possible to the carburetor.
The hole in the top of the cap is a vent and should be left open and kept clear to assure proper regulator function.

Remember, after installation, check for any leaks. Your safety depends on it.

SERVICE PARTS AND ACCESSORIES

For warranty information, please see our website at www.quickfueltechnology.com.
For further questions, please contact our technical department at 1-270-793-0900.

99-30-7025
Revision Date: 12-17-13

Figure 1