Quadra-Fire MT VERNON STOVE AE, MT VERNON INSERT AE Cleaning Instructions Manual
R
MT VERNON STOVE AE & MT VERNON INSERT AE
Heat Exchanger & Exhaust Cleaning Instructions
WARNING
Fire Risk
For trouble free use of your pellet appliance you must perform cleaning
as called for in these instructions. Not doing so will result in:
• Poor operating performance
• Smoke spillage into the home
• Overheating of components
Not properly cleaning your appliance on a regular basis will void your
warranty.
Refer to your Owner’s Manual for complete cleaning
www.quadrare.com
instructions for all components.
7014-139F
June 27, 2008
R
Firepot Air
Holes
Firepot
Floor
Firepot Exploded View
Baffle
Latches
Ashpan
Heat Exchanger
Insert flat head screwdriver into “V”
section and push down and the
bottom of the latch will fall forward
off of post
Locating ears - 1 on
each side. Fit behind
bottom edge
CAUTION
The appliance must be in complete shutdown, completely
cool and the exhaust blower off before performing any
cleaning or maintenance. There is a risk of shock if
the appliance is not unplugged before servicing the
appliance.
NOTE: Performing this routine service will require approximately 20
minutes a month depending on type and quality of fuel you burn.
CLEANING OR FREQUENCY DAILY WEEKLY
INSPECTION
FIREPOT
Softwood Pellets
FIREPOT
Hardwood Pellets
FIREPOT
Corn, Wheat, or Sunower Seeds
Every 5 bags
Every 3 bags
Every 1 bag
-OR-
-OR-
-OR-
PROPER SHUTDOWN PROCEDURE
1.
Set the wall control thermostat to “OFF” on AUTOMATIC/
MANUAL SETTING screen and let the appliance completely cool. The exhaust blower must be off before you
can unplug the appliance before servicing.
2. Smoke spillage into the room can occur if the appliance
is not cool before unplugging.
EVERY 2
WEEKS
YEARLY
X
X
X
ASHPAN
Wood Pellets
ASHPAN
Alternate Fuel
HEAT EXCHANGER Every 1 ton of
EXHAUST BLOWER
Every 5 bags
Daily
fuel
Every 3 tons of
fuel
-OR-
-OR-
-OR-
-OR-
X
X
X
X
FIREPOT MAINTENANCE
Page 2
The repot oor and repot air holes will need to be
scraped occasionally depending on the quality of fuel
being used. Use a putty knife, a at head screwdriver
or the repot clean-out tool provided to remove excess
carbon from the repot.
7014-139F
June 27, 2008
Loading...