Prima PJE001 User Manual

Juice Extractor

MODEL PJE001

USER GUIDE WITH RECIPES

Visit our web site at: www.buyprima.com

IMPORTANT SAFEGUARDS

1. Please read through the information and safety advice contained in these operating instructions
carefully and thoroughly before you use the Juicer for the first time.

2. Place Juice Extractor on a flat, stable, cool work surface.

3. Never allow children to operate this appliance.

4. Make sure that the voltage shown on the rating plate corresponds with that of the mains supply. The
rating plate can be found on the bottom of the motor block. The product is only to be connected to an
AC supply (~). The motor must always be switched off before the product is connected to the main
supply. ( ‘0’ setting).

5. This Juicer has a safety switch and only operates when the two safety handles are locked into place.

6. Do not use the Juice extractor continually for more than one minute at a time. If the machine
becomes too hot then it will automatically shut down until the motor is cool enough to start up again.
Once it has shut down the machine normally takes about 15 minutes to cool down before it can be
used again.

7. If the supply cord is damaged, its must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard. Do not attempt to repair the device yourself.

8. Do not immerse the unit in water or any other liquid. Simply wipe with soft damp cloth.

9. Close adult supervision is necessary when using this or any appliance where children are present.

10. Never leave the appliance connected to the mains and unattended.

11. Avoid contacting moving parts. Always use the Juicer stick to feed fruit into the feeding tube –
NEVER use fingers.

12. If food becomes stuck in the Feeding Tube NEVER try to remove with fingers use the Juicer Stick to
push the food through. If this does not work switch off the machine and unplug, wait until it has
cooled down and disassemble and clean.

13. Do not use any attachments other than those supplied. To do so would invalidate your warranty.

14. Do not let the cord hang over the edge or counter top.

15. Never interfere with or try to bypass the safety switches.

16. Make sure when removing parts to clean the power is switched off and unplugged from the wall
socket.

17. Do not use out doors.

18. Please note that this appliance is for domestic use only.

Technical Information

Voltage/frequency: 230V~50Hz (350W)
Juice capacity: 700ml
Pulp capacity: 700ml

Parts and Assembly

IMPORTANT

THE JUICE EXTRACTOR IS EQUIPPED WITH A SAFETY INTERLOCK SWITCH. THIS IS FITTED TO PREVENT
THE MOTOR FROM BEING ACTIVATED WHILE THE MACHINE IS DISASSEMBLED. THE MOTOR WILL NOT

RUN UNLESS THE REMOVABLE TRANSPARENT COVER IS ON SECURELY AND LOCKED INTO PLACE
WITH THE SAFETY LOCKING HANDLES.

ASSEMBLY

Before first use it is a good idea to familiarise yourself with the assembly/disassembly of the
unit.

ASSEMBLY

1. The appliance should be unplugged from the mains before assembly or disassembly.

2. Slot the pulp container into right of the machine. Slot the juice container into the left of the

machine.

3. Place the Removable White Cover onto the main body.

4. Attach the Stainless Steel filter net and blade onto the main body, through the

Removable White Cover hole, by lining up the groves on the bottom with those on the top
of the main body and pushing down until you hear it lock into place.

5. Attach the top transparent cover and place the juicer stick in the food chute.

NOTE: Line up the two small cut out of plastic sections on the bottom of the Removable
Transparent Lid with those two indents on the top of the Removable White Cover.

6. Make sure the housing unit is locked with the safety lockers in place by hooking them

onto the top cover and pushing them downwards until they clip in place.

7. The juicer will not work for safety reasons if the safety lockers are not locked in place

correctly.

DISASSEMBLY

1. Remove the juicer stick and the pulp and juice containers.

2. To remove the Removable Transparent Cover pull both safety lockers upwards and

outwards from the bottom. Release and lift off the top cover.

3. Lift the Removable White Cover by lifting upwards.

4. Lift the filter net off by strongly pulling upwards.