610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
PATENTS
Patented under one or more of the following U.S. Patents:
5345471, 5523760, 5457394, 5465094, 5512834, 5521600, 5682164, 5630216,
5510800, 5661490, 5609059, 5774091, 5757320, 5581256, 5832772, 5519400,
5767953, 5767627, 5589838, 5563605, 5661385, 5517198, 5610611, 5883591,
5805110, 5754144, 7088284, and 7215278.
Other patents have been applied for.
TRADEMARKS
The names of actual companies and products mentioned herein may be the
trademarks of their respective owners. Any rights not expressly granted herein
are reserved.
APS-SUPPLY.COM
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
Operator Display Description
CD6102 – the CD6102 operator display family is a Common Display used with all
the PreView CAN based sensors. This display provides the vehicle operator with
a visual indication of a detected object. The display unit also contains a buzzer
to provide an audible alert that will increase in rate as an object becomes closer,
providing the operator with another cue that an object is being detected.
A switch is provided on the front panel of the display allowing the vehicle operator
the ability to adjust the buzzer volume to three different levels or to provide an
alarm acknowledge and silence the buzzer.
CD6102-2 – is a CD6102 display factory congured for a two sensor PreView
system.
CD6102 OC – is a sealed display for an open cab application. The display provides
the vehicle operator with a visual indication of a detected object. This display
does not contain a buzzer for audible alert or a switch to adjust the volume.
The operator display continuously monitors communication from the PreView
sensor and in the event of a system failure or malfunction, will notify the operator
with a fault indication.
APS-SUPPLY.COM
The PreView® system is a blind spot collision warning system designed to
supplement other safety practices and/or devices. The machine operator is
always the rst line of defense when safely operating a vehicle.
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
Display Unit Function
Figure 1. PreView® Operator Display
ItemDescription
Status LED
Range Indications
Display Buzzer*
Volume Control/Ack Switch
APS-SUPPLY.COM
Illuminates green continuously after power is applied to the system.
The status will change from green to red if a system malfunction
occurs.
Illuminates to give operator a relative distance measurement to the
closest detected object. LED’s operate from the left to right, with a
closer object resulting in more LED’s illuminated.
Sounds audible tones to alert operator of obstacles. The speaker
pulse rate will increase as the vehicle gets closer to an object.
This momentary push button switch allows three different buzzer
volume levels to be selected. It can also be congured as an
acknowledge switch to silence the buzzer using the Service Tool.
Table 1. Operator Display Description
*CD6102 OC display does not contain a buzzer or Volume Control / Ack Switch
Mounting Instructions
Display Unit Installation
The display unit should be mounted where the vehicle operator can easily view
it while backing. The ideal location for this is on the dash positioned by either
windshield pillar. This will allow the operator view of the display while also
looking out one of the side mirrors.
The PreView display unit comes equipped with a mounting bracket and
hardware. If desired, the display unit can be mounted to the display bracket with
the supplied hardware. This bracket can then be mounted in the vehicle cab as
desired.The display receives power from the sensor. See installation guide and
supplied manuals for more information.
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
Troubleshooting
Display Status LED is not illuminated:
•Verify that DC power (9-33V) is applied to the sensor.
•Verify that the cable between the sensor and display is connected.
Display Status LED is RED:
•Check connection between display and sensor.
Display Status LED is RED and one Yellow LED is illuminated:
LED Error CodePossible Reason
LED #5 onNo communication with any sensor(s)
LED #4 onBuilt in Self Test Error – Contact Factory
LED #3 onMissing sensor(s)
All the display LED’s are illuminated when sensor is mounted:
APS-SUPPLY.COM
•Verify the sensor is pointing outward from the vehicle in an open area with
no obstructions. This may require removing the mounting screws and lifting
the sensor out away from the rear of the vehicle. If the display LED’s are not
active when moved away from the vehicle, but are active when mounted,
then the sensors mounting position will have to be moved.
Sensor is detecting the ground, indicated by a few of the display
LED’s being lit:
•In an open eld, either move the sensor up higher or slightly angle the sensor
upward 5 to 10 degrees. The minimum recommended mounting height is 24
inches.
For Questions call Preco Electronics, Inc™ 1-866-977-7326 between 7:30
AM and 4:30 PM Mountain Standard Time
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
Specications
DISPLAY SPECIFICATIONS (Typical)
Housing Material: Polycarbonate/ABS alloy
Dimensions: 1.00”H x 2.25”W x 2.00”D (2.5cm x 5.7cm x 5.1cm)
Weight: 0.25 lb. (0.11 kg)
Mounting: User dependent
ELECTRICAL SPECIFICATIONS
Power supplied by sensor
OPERATING CHARACTERISTICS
Warning Ranges: 5 zones
COMMUNICATION
Physical Layer: CAN 2.0B, 250 KB/s
Protocol Layer: SAE J1939 Extended
Data Update Rate: 70 ms
APS-SUPPLY.COM
Figure 2. Mating End View and Connector Pin Out
PRODUCT MANUFACTURED IN THE USA
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
Warranty Information
MANUFACTURER STANDARD LIMITED WARRANTY AND LIMITATION OF LIABILITY
Manufacturer warrants that on the Date of Purchase this Product will conform to Manufacturer’s published
specications for the product, which are available from Manufacturer on request, and Manufacturer warrants
that the product is free from defects in materials and workmanship. This Limited Warranty for the Display
extends for sixty (60) months from the date of shipment. Manufacturer will, at its option, repair or replace any
product found by Manufacturer to be defective and subject to this Limited Warranty.
This Limited Warranty does not apply to parts or products that are misused; abused; modied; damaged
by accident, re or other hazard; improperly installed or operated; or not maintained in accordance with the
maintenance procedures set forth in Manufacturer’s Installation and Operating Instructions.
To obtain warranty service, you must ship the product(s) to the specied Manufacture location within thirty (30)
days from expiration of the warranty period. To obtain warranty service you must call Preco Customer Service
at 866-977-7236 or 208-323-1000, or fax your request to 208-323-1034. Customer Service will issue warranty
authorization and further instructions. You must prepay shipping charges and use the original shipping container
or equivalent.
APS-SUPPLY.COM
EXCLUSION OF OTHER WARRANTIES: MANUFACTURER MAKES NO OTHER WARRANTIES, EXPRESSED,
IMPLIED OR STATUTORY. THE IMPLIED WARRANTIES FOR MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE HEREBY EXCLUDED AND SHALL NOT APPLY TO THE PRODUCT. BUYER’S
SOLE AND EXCLUSIVE REMEDY IN CONTRACT, TORT OR UNDER ANY OTHER THEORY AGAINST
MANUFACTURER RESPECTING THE PRODUCT AND ITS USE SHALL BE THE REPLACEMENT OR
REPAIR OF THE PRODUCT AS DESCRIBED ABOVE.
LIMITATION OF LIABILITY: IN THE EVENT OF LIABILITY FOR DAMAGES ARISING OUT OF THIS LIMITED
WARRANTY OR ANY OTHER CLAIM RELATED TO MANUFACTURER’S PRODUCTS, MANUFACTURER’S
LIABILITY FOR DAMAGES SHALL BE LIMITED TO THE AMOUNT PAID FOR THE PRODUCT AT THE TIME
OF ORIGINAL PURCHASE. IN NO EVENT SHALL MANUFACTURER BE LIABLE FOR LOST PROFITS,
THE COST OF SUBSTITUTE EQUIPMENT OR LABOR, PROPERTY DAMAGE, OR OTHER SPECIAL,
CONSEQUENTIAL OR INCIDENTAL DAMAGES BASED UPON ANY CLAIM FOR BREACH OF CONTRACT,
NEGLIGENCE OR OTHER CLAIM, EVEN IF MANUFACTURER OR A MANUFACTURER’S REPRESENTATIVE
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES
Manufacturer shall have no further obligation or liability with respect to the product or its sale, operation and
use, and Manufacturer neither assumes nor authorizes the assumption of any other obligation or liability in
connection with such product.
This Limited Warranty gives you specic legal rights, and you may also have other legal rights, which vary, from
state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above exclusion or limitation may not apply to you.
Any oral statements or representations about the product, which may have been made by salesmen or
Manufacturer representatives, do not constitute warranties. This Limited Warranty may not be amended,
modied or enlarged, except by a written agreement signed by an authorized ofcial of Manufacturer that
expressly refers to this Limited Warranty.
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
PreView® Add-On Options
PreView® Plus Camera / Monitor System – Ultimate safety and object detection system congurable with up
to 4 cameras and 24 sensors.
PreView Safety Alert System – The PreView Radar Sensor detects an object in the blind spot. Once the object
is detected, PreView triggers the back-up alarm to either increase the sound of the alarm OR change the beep
rate to alert pedestrians outside of the vehicle of the danger.
APS-SUPPLY.COM
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
NOTES
APS-SUPPLY.COM
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
VEHICLE SAFETY
NOTES
APS-SUPPLY.COM
APS USA
610 Gateway Center Way, Suites J & K
San Diego, CA 92102 USA
P: 1 619 263 4164
www.aps-supply.com
F: 1 619 263 6814
APS Australia
U48 / 9 Vision Street,
Wangara WA 6065 Australia
P: 61 (8) 9302 2369
F: 61 (8) 6305 0047
APS: Singapore
Colombia
Chile
Perú
Brasil
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.