For details, refer to "Important symbols for good services".
K-ZZW. NOV. 2003 printed in Japan
1234
SAFETY INFORMATION
CAUTION
A
This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer.
Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely
complex products such as those covered by this manual.
repair
Improperly performed repairs can adversely affect the safety and reliability of the product and may void the
warranty.
trying to do so
ARNING
W
This product contains lead in solder and certain electrical parts contain chemicals which are known to the
state
B
Health & Safety Code Section 25249.6 - Proposition 65
If you are not qualified to perform the repair of this product properly and safely, you should not risk
and refer the repair to a qualified service technician.
of California to cause cancer, birth defects or other reproductive harm.
- CD Player Service Precautions
1. Before disassembling the unit, be sure to turn off the
C
D
power. Unplugging and plugging the connectors during power-on mode may damage the ICs inside the
unit.
2. To protect the pickup unit from electrostatic discharge during serviving, take an appropriate treatment(shorting-solder) by referring to "the DISASSEMBLY" on page 56.
3. After replacing the pickup unit, be sure to check
the grating.(See p.52.)
E
F
2
1234
DEH-P460MP/XM/UC
5678
[ Important symbols for good services ]
In this manual, the symbols shown-below indicate that adjustments, settings or cleaning should be made securely.
When you find the procedures bearing any of the symbols, be sure to fulfill them:
1. Product safety
You should conform to the regulations governing the product (safety, radio and noise, and other regulations), and
should keep the safety during servicing by following the safety instructions described in this manual.
2. Adjustments
To keep the original performances of the product, optimum adjustments or specification confirmation is indispensable.
In accordance with the procedures or instructions described in this manual, adjustments should be performed.
3. Cleaning
For optical pickups, tape-deck heads, lenses and mirrors used in projection monitors, and other parts requiring cleaning,
proper cleaning should be performed to restore their performances.
4. Shipping mode and shipping screws
To protect the product from damages or failures that may be caused during transit, the shipping mode should be set or
the shipping screws should be installed before shipping out in accordance with this manual, if necessary.
A
B
5. Lubricants, glues, and replacement parts
Appropriately applying grease or glue can maintain the product performances. But improper lubrication or applying
glue may lead to failures or troubles in the product. By following the instructions in this manual, be sure to apply the
prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed
ones should be used.
4.2 PANEL UNIT ............................................................................................................................................ 40
4.4 CD CORE UNIT(S10WMA)......................................................................................................................42
5. ELECTRICAL PARTS LIST ............................................................................................................................44
6.1 CD ADJUSTMENT................................................................................................................................... 50
6.2 CHECKING THE GRATING AFTER CHANGING THE PICKUP UNIT....................................................52
7.2.1 IC ..........................................................................................................................................................60
OTES : • Parts marked by " * " are generally unavailable because they are not in our Master Spare Parts List.
A
• Screw adjacent to mark on the product are used for disassembly.
"
• For the applying amount of lobricants or glue, follow the instructions in this manual.
(In the case of no amount instructions,apply as you think it appropriate.)
The > mark found on some component parts indicates
the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of
identical designation.
*Capacitors
Code Practical value
103 0.01uF
101/10 100uF/10V
CN1901
C
B
PANEL UNIT
A B
18
1234
DEH-P460MP/XM/UC
5678
A
A-b
A
FM : 5.6dBs
AM : -4.9dBs
CD : 10.1dBs
IP-BUS : 10.3dBs
TUNER AMP UNIT
3A
>
FM : 4.8dBs
AM : -5.7dBs
CD : 9.3dBs
IP-BUS : 9.5dBs
FRONT
OUTPUT
REAR
OUTPUT
REAR
OUTPUT
B
LER
DETACH
SENSE
600µH
FM : 31.6dBs
AM : 21.1dBs
CD : 36.1dBs
IP-BUS : 36.3dBs
CEK1208
10A
>
C
D
E
WIRED
REMOTE
CONTROL
DEH-P460MP/XM/UC
56
: UC model only
: ES model only
F
A
7
8
19
1234
A
A-b
B
IP-BUS : 2.2dBs
21
3
SYSTEM CONTROLLER
C
A-b
A-a
A-a
D
CN901
D
E
CD : 0.0dBs
F
FM(100%) : -19.5dBs
AM(30%) : -30dBs
A-a
20
1234
DEH-P460MP/XM/UC
5678
SYSTEM CONTROLLER
A
SENSE
DETACH
4
A-b
B
EJECT
CN1901
C
PANEL UNIT
B
A-b
A-a
A-a
*Capacitors
Code Practical value
103 0.01uF
101/10 100uF/10V
C
D
E
FM/AM TUNER UNIT
DEH-P460MP/XM/UC
56
Symbol indicates a resistor.
No differentiation is made between chip resistors and
discrete resistors.
Symbol indicates a capacitor.
No differentiation is made between chip capacitors and
discrete capacitors.
For resistors and capacitors in the circuit diagrams, their resistance values or
capacitance values are expressed in codes:
Ex. *Resistors
Code Practical value
123 12k ohms
NOTE :
103 10k ohms
A-a
7
8
The > mark found on some component parts indicates
the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of
identical designation.
F
B
21
1234
A
>
10A
FRONT
FM : 4.8dBs
AM : -5.7dBs
CD : 9.3dBs
IP-BUS : 9.5dBs
B
OUTPUT
REAR
OUTPUT
REAR
OUTPUT
>
3A
CEK1208
600µH
TUNER AMP UNIT
A
C
A-b
A-a
D
FM : 5.6dBs
AM : -4.9dBs
CD : 10.1dBs
E
IP-BUS : 10.3dBs
F
A-b
22
21
DEH-P460MP/XM/UC
1234
3
10A
CEK1208
5678
A
>
FM : 31.6dBs
AM : 21.1dBs
CD : 36.1dBs
IP-BUS : 36.3dBs
600µH
: UC model only
: ES model only
WIRED
REMOTE
CONTROL
B
C
A-b
A-a
D
SENSE
DETACH
4
DEH-P460MP/XM/UC
56
E
F
A-b
7
8
23
Loading...
+ 54 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.