Philips NE5232D, NE5232N, SA5232D, SA5232N, AU5232N Technical data
...
查询AU5232供应商查询AU5232供应商
INTEGRATED CIRCUITS
NE/SA/AU5232
Matched dual high-performance
low-voltage operational amplifier
Product data 2002 May 21
Philips Semiconductors Product data
Matched dual high-performance
low-voltage operational amplifier
DESCRIPTION
The NE/SA/AU5232 is a matched, low voltage, high performance
dual operational amplifier . Among its unique input and output
characteristics is the capability for both input and output rail-to-rail
operation, particularly critical in low voltage applications. The output
swings to less than 50 mV of both rails across the entire power
supply range. The NE/SA/AU5232 is capable of delivering 5.5 V
peak-to-peak across a 600 Ω load and will typically draw only
700 µA per amplifier. The bandwidth is 2.5 MHz and the 1% settling
time is 1.4 µs.
FEATURES
•Wide common-mode input voltage range: 250 mV beyond both
rails
•Output swing within 50 mV of both rails
•Functionality to 1.8 V typical
•Low current consumption: 700 µA per amplifier
•±15 mA output current capability
•Unity gain bandwidth: 2.5 MHz
•Slew rate: 0.8 V/µs
•Low noise: 33 nV/√Hz
•Electrostatic discharge protection
•Short-circuit protection
•Output inversion prevention
NE/SA/AU5232
PIN CONFIGURATION
D, N Packages
OUTPUT A
INVERTING INPUT A
NON INVERTING INPUT A
1
2
AB
–+
3
V–
45
Figure 1. Pin configuration.
APPLICATIONS
•Automotive electronics
•Signal conditioning and sensing amplification
•Portable instrumentation
– Test and measurement
– Medical monitors and diagnostics
– Remote meters
•Audio equipment
•Security systems
•Communications
– Pagers
– Cellular telephone
– LAN
– 5 V Datacom bus
•Error amplifier in motor drives
•Transducer buffer amplifier
+
–
SL01163
8
7
6
V+
OUTPUT B
INVERTING INPUT B
NON INVERTING INPUT B
ORDERING INFORMATION
ORDER CODE DESCRIPTION TEMPERATURE RANGE DWG #
NE5232D 8-Pin Plastic Small Outline (SO) package 0 °C to +70 °C SOT96-1
NE5232N 8-Pin Plastic Dual In-Line Package (DIP) 0 °C to +70 °C SOT97-1
SA5232D 8-Pin Plastic Small Outline (SO) package –40 °C to +85 °C SOT96-1
SA5232N 8-Pin Plastic Dual In-Line Package (DIP) –40 °C to +85 °C SOT97-1
AU5232N 8-Pin Plastic Dual In-Line Package (DIP) –40 °C to +125 °C SOT97-1
AU5232D 8-Pin Plastic Small Outline (SO) package –40 °C to +125 °C SOT96-1
2002 May 21 853–2347 28261
2
Philips Semiconductors Product data
T
b
Matched dual high-performance
low-voltage operational amplifier
ABSOLUTE MAXIMUM RATINGS
SYMBOL PARAMETER RATING UNIT
V
CC
V
ESD
V
S
V
DP
I
DP
V
i(dif)
V
i(CM)
V
i(CM)
P
D
T
j
V
SC
T
stg
T
sld
θ
JA
NOTES:
1. Each pin is protected by ESD diodes. The voltage at any pin is limited by the ESD diodes.
2. The differential input of each amplifier is limited by two internal diodes, connected in parallel and opposite to each other. For more differential
input range, use differential resistors in series with the input pins.
3. The maximum operating junction temperature is +150 °C. At elevated temperatures, devices must be derated according to the package
thermal resistance and device mounting conditions. Derates above +25 °C: N package at 9.5 mW/°C; D package at 6.25 mW/°C.
4. Simultaneous short circuits of two amplifiers to the positive or negative rail can exceed the power dissipation ratings and cause eventual
destruction of the device.
5. Guaranteed by design.
Single supply voltage 7 V
ESD protection voltage at any pin
5
human body model 2000 V
robot model 200 V
Dual supply voltage ±3.5 V
Voltage at any device pin
Current into any device pin
Differential input voltage
1
1
2
VS ± 0.5 V
Common-mode input voltage (positive) VCC + 0.5 V
Common-mode input voltage (negative) VEE – 0.5 V
Power dissipation
Operating junction temperature
Supply voltage allowing indefinite output short circuit to either rail
3
3
3,4
Storage temperature range –65 to +150 °C
Lead soldering temperature (10 sec max) +230 °C
Thermal impedance
8-pin plastic DIP °C/W
8-pin plastic SO °C/W
NE/SA/AU5232
±50 mA
0.5 V
500 mW
+150 °C
7 V
RECOMMENDED OPERATING CONDITIONS
SYMBOL PARAMETER RATING UNIT
V
V
V
CC
V
i(CM)
i(CM)
am
S
Single supply voltage +2 to +5.5 V
Dual supply voltage ±1 to ±2.75 V
Common-mode input voltage (positive) VCC + 0.25 V
Common-mode input voltage (negative) VEE – 0.25 V
Temperature
NE 0 to +70 °C
SA –40 to +85 °C
AU –40 to +125 °C
2002 May 21
3
Loading...