Philips MCM395 12 Quick Start Guide

Page 1
MCM395
What’s in the Box?
You should find these items upon opening the box.
FM antenna Remote Control
1
Quick Start Guide
Quick Start Guide
User Manual
User manual
Pull out the plastic protective sheet before use.
2
Page 2
1
Connect the speaker cables.
2
Connect the FM antenna.
Tip
See the User Manual for how to connect other equipment to this system.
FM wire antenna
2
Speaker
(right)
AC power cord
1
Speaker
(left)
Page 3
Setting the clock
IMPORTANT! – To set clock in the Eco Power mode, press and hold ECO POWER/ STANDBY-ON standby mode first before proceeding with the procedures below.
2
on the set for 3 seconds or more to switch to normal
1
In standby mode, press and hold CLOCK on the remote control.
SET CLOCK is displayed briefly. Then, the clock digits for the hours flash.
2
Press 9 on the remote control to select clock mode.
Then, the clock digits for the hours continue to flash.
3
Adjust VOLUME -/+ (or press VOL +/- on the remote control) to set the hours.
4
Press CLOCK again.
The clock digits for the minutes flash.
5
Adjust VOLUME -/+ (or press VOL +/- on the remote control) to set the minutes.
6
Press CLOCK to confirm the time.
C
Enjoy
Notes for remote control: – First select the source you wish to control by pressing one of the source select keys on the remote control (for example CD, TUNER). – Then select the desired function (for example
É
, S, T).
Playing a disc
1
Press OPEN/CLOSEç to open the disc tray and load in a disc, then press the same button again to close the disc tray.
Make sure the label side of the disc is facing up.
2
Press ÉÅ to start playback.
3
To stop playback, press 9.
d
o
i
r
e
p
d
e
g
D
o
n
n
o
l
o
r
p
o
t
a
p
r
u
o
t
t
i
h
n
g
i
l
d
i
n
r
u
e
s
c
t
Page 4
C
Enjoy
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1), USB flash players work with this Hi-Fi system).
1
Insert the USB device’s USB plug into the socket on the set.
(USB 2.0 or USB1.1), memory cards (requires an additional card reader to
2
Press SOURCE once or more (or USB on the remote control) to select USB.
3
Play the USB’s audio files as you do with the albums/tracks on a CD.
Programming and tuning to radio stations
1
Press SOURCE on the front panel repeatedly (or TUNER on the
remote control) to select the tuner source.
2
Press PROG for more than two seconds to program all available stations in order of waveband.
3
Press ALBUM/PRESET 4 or 3 until the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the accompany owner's manual.
C Royal Philips Electronics N.V. 2008
All rights reserved.
PDCC-0804
Eng
Loading...