Philips HR 7717, HR 7715 Service Manual

Use Service Manual 4822 729 21717 Electronic circuit / Switch bracket / Housing Items 9 / 8 / 4
1997-04-01
HR7715 HR7717
DAP144
MSH-coding 8837 715 00000
8837 717 00000
Alterations:
Item 9 Electronic circuit: a third micro-switch was added on the board. 4822 214 12271 Item 8 Switch braket: it was added another driving flap for the third micro-switch. 4822 464 10292 Item 4 Housing: the panel was modified with the creation of the Pulse switch. 4822 441 11984
Former situation Current situation
W15
W11
W12
W15
W11
W12
Item 9
+
ON
OFF
PULSE
+
ON
OFF
PULSE
O/M I
Item 8
Item 4
O
M
PCS 88 424 4822 729 21804
I
Interchangeability:
Only the modified parts (current situation) will be available as spare parts and in order to use them in old sets the following changes must be made:
Electronic circuit: (item 9)
Switch braket: (item 8)
Housing (item 4)
On the copper side (opposite side to the one shown in the figure): – Using a flexible wire, make a jumper
between the inner contacts of the Off and Pulse micro-switchs (detail A).
()
– Using solder, make a jumper between the
points indicated in detail B.
()
B
PULSE
C
On the component side (as shown in the
()
figure): – Remove the transistor (detail C), cutting its
A
OFF
+
3 terminals off.
ON
Total interchangeable.
W12
W11
Not interchangeable. It can only be used in old sets (serial numbers up to 6523) if the electronic circuit and the switch bracket are also replaced.
W15
Loading...