Philips FW390C/34, FW390C/22, FW390C/19 User Manual

Mini HiFi System
FW390C
1
Important notes for users in the U.K. Mains plug
FrançaisEnglish
1 Remove fuse cover and fuse.
Español
2 Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type. 3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an
Deutsch ∂ППЛУИО¿PortuguêsSuomiDanskSvenskaItalianoNederlands
appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.
Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured black.
• Connect the brown wire to the terminal marked L or coloured red.
• Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.
Italia
DICHIARAZIONE DI CONFORMITA’
Si dichiara che l’apparecchio FW390C Philips risponde alle prescrizioni dell’art. 2 comma 1 del D.M. 28 Agosto 1995 n. 548.
Fatto a Eindhoven , il 30/1/1999
Philips Consumer Electronics
5616 JB Eindhoven, The Netherlands
Philips, Glaslaan 2
Norge
Typeskilt finnes på apparatens underside.
Observer:
Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten.
For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.
Nettbryteren er sekundert innkoplet.
2
INDEX
CLASS 1
LASER PRODUCT
English .....................................4
Français .................................25
Español ..................................45
Deutsch..................................65
Nederlands............................85
Italiano.................................105
Svenska ...............................125
Dansk ...................................145
Suomi ...................................165
Português ............................183
∂ППЛУИО¿
............................ 203
EnglishFrançais
Español
NederlandsItalianoSvenskaDanskSuomiPortuguês∂ППЛУИО¿ Deutsch
3
English
4
CONTENTS GENERAL INFORMATION SAFETY INFORMATION
General Information ..........................5
Safety Information .............................5
Preparation ................................... 6 - 7
Controls .........................................8 - 9
Operating The System ............ 10 - 11
CD ...............................................12 - 14
Tuner .......................................... 14 - 16
Tape............................................ 16 - 17
Aux .....................................................17
Recording.................................. 18 - 19
Clock ..................................................19
Timer .......................................... 19 - 20
Maintenance ....................................20
Specifications ..................................21
Troubleshooting............................... 22
General Information
• The type plate (which contains the serial number) is located at the rear of the system.
• Recording is permissible if copyright or other rights of third parties are not infringed.
• This product complies with the radio interference requirements of the European Community.
Environmental Information
All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easily separable into three mono-materials: cardboard (box), polystyrene foam (buffer) and polythene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Accessories
– Remote control – Batteries (2 x AA size) for remote control – AM loop antenna – FM wire antenna – AC power cord
(Supplied)
Safety Information
• Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer. The type plate is located at the rear of your system.
• When the system is switched on, do not move it around.
• Place the system on a solid base (e.g. a cabinet).
• Place the system in a location with adequate ventilation to prevent internal heat build-up in your system.
• Do not expose the system to excessive moisture, rain, sand or heat sources.
• Under no circumstances should you repair the system yourself, as this will invalidate the warranty!
• If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.
• Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.
• To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.
English
5
PREPARATION
English
Rear Connections
B
LR
SUBWOOFER
OUT
FRONT
A
FM AERIAL
75
+
R
– –
L
+
AM AERIAL
AC
MAINS
~
F
AUX IN
STANDBY ON
E
V
L
E
R
L
E
C
F
O
O
N
O
T
W
R
B
O
U
L
S
MIN MAX
CUT OFF FREQUENCY
HIGH POWER SUBWOOFER
60Hz 150Hz
E
C
AUDIO OUT
6
D
PREPARATION
+
-
+
-
A AM Loop Antenna
Connection
Connect the supplied loop antenna to the AM AERIAL terminal. Place the AM loop antenna far away from the system and adjust its position for the best reception.
B FM Wire Antenna
Connection
Connect the supplied FM wire antenna to the FM 75 terminal. Adjust the position of the FM antenna for the best reception.
Outdoor Antenna
For better FM stereo reception connect an outdoor FM antenna to the FM AERIAL 75 terminal using a 75 coaxial wire.
C Speaker Connections
• Connect the right speaker to Front terminal R, with the red wire to + and the black wire to -.
• Connect the left speaker to Front terminal L, with the red wire to + and the black wire to -.
• Clip the stripped portion of the speaker wire as shown.
12 mm
unlock lock
D Connecting other
equipment to your system
You can connect the audio left and right OUT terminals of a TV, VCR, Laser Disc or DVD player to the AUX IN terminals at the rear of the system.
E Subwoofer Out Connection
You can connect either an optional active subwoofer or an optional wireless active subwoofer to the SUBWOOFER OUT terminal. The wireless system uses a radio frequency transmitter. The subwoofer reproduces just the low bass effect (e.g. explosions, the rumble of the spaceships, etc.). Be sure to follow the instructions supplied with the subwoofer unit.
Note: – Availability of wireless transmitter and
its peripherals are subjected to the approval of local authorities. Please check with respective local safety or approving authority.
F AC Power Supply
After all other connections have been made, connect the AC power cord to the system and to the wall outlet.
Inserting batteries into the Remote Control
• Insert the batteries (Type R06 or AA) into the remote control as shown in the battery compartment.
• To avoid damage from possible battery leakage, remove dead batteries or batteries that will not be used for a long time. For replacement, use type R06 or AA batteries.
English
7
Loading...
+ 15 hidden pages