Philips Dynalite DDLE801 Installation Instructions Manual
DDLE801
RJ12
215 mm (8.46 in)
93 mm (3.66 in)
64 mm (2.52 in)
45 mm
(1.77 in)
45 mm
(1.77 in)
1
www.lighting.philips.com/dynalite
Leading Edge
Dimmer Controller
Installation Instructions
Instructions d’installation
Installationsanweisungen
Instrucciones de instalación
Istruzioni per l’installazione
Installatie-instructies
インストール手 順
安装指示
40° C (104° F)
-5° C (23° F)
≤
90%
IEC Pollution Degree II If ventilation is restricted, apply load de-rating to outputs.
Devices must be installed in an
approved enclosure by a qualied
electrician in accordance with all
national and local electrical and
construction codes and regulations.
Les appareils doivent être installés dans un lieu jugé
apte, par un électricien qualié et conformément
aux règles et normes locales et nationales en
matière d’électricité et de construction.
Die Geräte müssen von einem geprüften Elektriker
entsprechend allen nationalen und lokalen Elektro
– und Bauvorschriften in einem zugelassenen
Gehäuse installiert werden.
Los dispositivos se deben instalar en un recinto
aprobado por un electricista cualicado de
acuerdo a todos los reglamentos eléctricos y de
construcción locales y nacionales pertinentes.
I dispositivi devono essere installati da un
elettricista qualicato in un luogo approvato, in
conformità a tutti gli standard e le norme nazionali
e locali vigenti in materia di impianti elettrici e
costruzioni edilizie.
Apparaten moeten door een erkende elektricien
worden geïnstalleerd in een goedgekeurde
behuizing in overeenstemming met alle nationale
en lokale elektriciteits – en bouwvoorschriften
en wetgeving.
デバイスを取り付ける際は、資格のある電気技師に依頼
し、電気と建設に関する国および地域のすべての法令に
従って、認可 されている筐体内に取り付けてください。
根据国家/地区及当地的电气与建筑规范和法规，该设
备必须由有资质的电工安装在经批准的外罩内。
E
N
N
L
µP
T 6.3A M205
T 6.3A M205
N
N
N
N
N
N
N
L
L
L
L
L
L
L
L
+12 V
D +
D -
GND
SHLD
AUX
DyNet
RS-485
DMX Rx
2 x RJ12
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
100-240 V
10 A
12 V 200 mA
0.56 Nm
5 Lb-in
≤ 2.5 mm
2
12+ AWG
SHLD
GND
D+ D-
+12 V AUX
SHLDD+GND
D-
+12 V
AUX
DyNet RS-485
≤ 2 A
GND AUX
<20 m
43
DyNet RS-485
65
L
N L
N
CH1
L N
CH2
L N
CH3
L N
CH4
L N
CH5
L N
CH6
L N
CH7
L N
CH8
≤ 8 A≤ 1 A/CH
≤ 800W100W/CHLED
INCANDESCENT
0.62 Nm
5.5 Lb-in
≤ 5 mm
2
10+ AWG
2
Philips Dynalite
www.lighting.philips.com/dynalite
© 2018 Philips Lighting. All rights reserved.
The manufacturer is not responsible for dimmable lamp selection. Each lamp/dimmer combination must be tested for compatibility prior to installation.
Installation of a home and building automation and control system shall comply with HD 60364-4-41. The temperature limits and current-carrying capacities for
the communication wires specied in HD 384.5.523 shall not be exceeded.
Professional dimmers rated > 1000 W are out of scope of EN 61000-3-2.
IEC Overvoltage Category III
Loading...