Perma Pure DM-060-24, DM-110-24 User Manual

PRINCIPLE OF OPERATION

DM™-Series gas dryers combine selectivity
of Nafion® gas dryers with the simplicity of
desiccant canister dryers. Gaseous sample
flowing through the dryer contacts only Nafion
tubing, which selectively absorbs water vapor
while retaining the remaining sample compo­nents in the gas stream. Water passing
through the tubing wall is absorbed by the
molecular seive desiccant. Scattered blue
indicating crystals can be observed through
the clear window to monitor the condition of
the desiccant.

DM™- Series

Gas Dryer

User Manual

Nafion® is a registered trademark of DuPont
DM™ is a trademark of Perma Pure LLC.

Bulletin 202

PERMA PURE

8 Executive Drive
Toms River, N.J. 08755
Phone: [phone]

732-244-0010
Fax: [phone]
e-mail: [e-mail]
Web Site: www.permapure.com

DM GAS DRYER SPECIFICATIONS

REPLACING DESICCANT

When blue indicating crystals turn pink, desiccant

needs to be replaced.

Model Number DM-060-24 DM-110-24

O.D. 0.060" 0.110"
I.D. 0.049" 0.085"
Flow Rate Up to 500mL/min Up to 1L/min
Housing 4.2"x2.4"x1.0" 5.0"x2.75"x1.5"
Desiccant 2.5 oz. 5.5 oz.
Drying/Charge 72L 150L

INSTALLATION

Luer Fittings

DM-060-24 include two sets of barb fittings:

1/16” and 1/8”

DM-110-24 include one set of 1/8” barb fittings

Units ship with plugs on the bulkhead fittings.
Before use, take plugs off and replace with barb
fittings.

1. Take off fittings/tubing

2. Remove snap-lock door on canister (Refer to

Snap-lock Door

Figure 1)

3. Empty spent desiccant

4. Refill with new desiccant

5. Replace snap-lock door

PART NUMBERS FOR REPLACEMENT

Desiccant

Fittings

Indicating Crystals

Figure 1

Part Number Description

DM-AR 1 Liter (provides 10 refills)
ME-060-24BB Replacement dryer for DM-060-24
ME-110-24BB Replacement dryer for DM-110-24

PERFORMANCE

Stainless Steel Compression Fittings

Compression fittings take 1/8” tubing

DM-Series dryers continuously dries sample
gases down to -30°C dew point depending on
flowrate.