Pentair Pressure Cleaner Adapter User Manual

Pressure Cleaner Adapter

UNLOCKED

For Use With Return Fitting Light

For AboveGround Pools

1. Determine which side of the Flow Director the water is
jetting from. (Fig. #1)

2. T urn the pump off .

3. Rotate the “Flow Director” pointing the flow of water
straight upwards. (Fig. #2)

4. Check the back of the pressure adapter to ensure that
the locks are in the unlocked position. (Fig. #3)

5. Catch the Adapter bottom on the bottom of the light
Flow Director . (Fig. #4)

(Fig. #1)

(Fig. #3)

FLOW DIRECTOR

(Fig. #2)

6. Swing Adapter up and hold securely to Flow Director .
(Fig. #4) NO TE: Do not push on Adapter lens to avoid
snapping lens out of position.

7. Rotate locks until Adapter is held in position. (Fig. #5)
Do not over tighten locks.

8. Turn the pump on.
NOTE: If it is desired to have Adapter outlet

on bottom side of Flow Director follow above
instructions and when finished:

A.Loosen nut on back of light to end of

threads.

B.Very carefully rotate Adapter and Flow

Director taking care not to tear liner with
Adapter locks.

C.Tighten nut on back of light (finger-tight only).

(Fig. #4)

CATCH

(Fig. #5)

RISK OF BODILY INJURY! DO NOT USE THIS DEVICE AS A STEP OR HAND HOLD. USING THIS
DEVICE AS A STEP OR HAND HOLD CAN RESULT IN BODILY INJURY OR PROPERTY DAMAGE.

Pentair Pool Products

1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-415
10951 West Los Angeles Ave., Moorpark, CA 93021 • [phone]

P/N 99791200 • 3-25-02

W ARNING