Pelco TXB-IP-P Specsheet

PRODUCT SPECIFICATION

camera solutions

Spectra® IV IP Network Communication Module

IP COMMUNICATION MODULE FOR SPECTRA IV DOME SYSTEMS

Product Features

• 2 Models to Fit All Spectra® IV Camera Systems

(Pressurized and Surface Mount Models Excluded)

– TXB-IP-F for Use with In-Ceiling Models

– TXB-IP-P for Use with Pendant Models

• Ability to Control and Monitor Video Over IP Networks, Without

Losing Analog Capabilities

• 3 Simultaneous Video Streams

Dual MPEG-4

–

– MJPEG

• Supported Protocols: TCP/IP, UDP/IP (Unicast, Multicast IGMP), UPnP,

DNS, DHCP

• Single Cat5e Cable for Video

• Bidirectional Full-Duplex Audio

The
Spectra

, RTP, NTP

TXB-IP

is a network-based communication module for all

®

IV camera systems (excluding pressurized and surface
mount models). This new product allows an existing Spectra IV
camera system to retain all of its current system and analog
capabilities while adding IP connectivity. When the

TXB-IP

is
plugged into a Spectra IV back box, the camera system features
Web and Endura

®

connectivity, as well as open architecture
connectivity to third-party software. Pelco offers an industry leading
application programming interface (API) for interfacing with Pelco's
network camera systems.

TXB-IP-F TRANSLATOR BOARD

(SHOWN INSTALLED WITH SPECTRA BACK BOX)

The

TXB-IP

allows simultaneous access to the camera from both an

analog and IP-based control point.

NOTE:

The TXB-IP can only be used with Spectra IV back boxes. It is

not compatible with Spectra III

™

and older model back boxes.

International Standards

Organization Registered Firm;

ISO 9001 Quality System

C3444 / REVISED 7-17-09

TECHNICAL SPECIFICATIONS

k

MODELS

TXB-IP-F Spectra IV IP communication module for

in-ceiling model back boxes

TXB-IP-P Spectra IV IP communication module for

pendant model back boxes

GENERAL

Construction Printed circuit board (PCB) enclosed in an

Mounting

Dimensions 3.44" L x 2.31" W x 0.69" H

Weight

Unit 0.2 lb (0.1 kg)
Shipping 1.0 lb (0.5 kg)

*Excludes pressurized and surface mount back boxes.

aluminum housing
Plugs into interconnect PCB of Spectra IV back

boxes*

(8.74 x 5.87 x 1.75 cm)

VIDEO

Compression MJPEG, MPEG-4 (available only with

Video Streams 3, simultaneous
Video Resolutions NTSC

4CIF 704 x 480 704 x 576
2CIF 704 x 240 704 x 288
CIF 352 x 240 352 x 288
QCIF 176 x 120 176 x 144

Bit Rate Configurable

MPEG-4 30 ips; 2 Mbps for primary stream, 1 Mbps for

MJPEG 15 ips, 3 Mbps, MJPEG

Web User Interface Pelco Device Utility interface for viewing

Users 5 simultaneous users MJPEG and MPEG-4

Minimum System
Requirements

Processor Intel® Pentium® 4 microprocessor, 1.6 GHz
Operating System Windows® 98, Windows 2000, Windows XP

Memory 512 MB RAM
Network Interface Card 100 megabits
Web Browser Internet Explorer 5.5 (or later); Mozilla®

Monitor Minimum of 1024 x 768 resolution, 16- or

Firmware Upgrade Pelco Device Utility or Endura Application
Supported Protocols TCP/IP, UDP/IP (unicast, multicast

Microsoft® Internet Explorer®)

PAL

secondary stream; implements EnduraView

HTTP, requires Java Runtime Environment
(JRE™)

unicast; unlimited number of users through
multicast (MPEG-4 only)

(or later) or Mac® OS X 10.3.9 (or later)

Firefox® 1.5 (or later))

32-bit pixel color resolution

IGMP),UPnP, DNS, DHCP, RTP, NTP

ELECTRICAL

Network Connection Ethernet 10/100Base-T, Cat5e cable with

Input V

oltage 24 VAC

Power Consumption 2.7 W

RJ-45 connector

CERTIFICATIONS

• CE, Class B

•

FCC, Class B

• UL/cUL listed

• C-Tick

™

AUDIO

Streaming Bidirectional: full or half duplex
Input/Output Terminal block, analog for microphone and

Compression G.711 PCM 8 bit, 8 kHz mono at 64 kbit/s

Pelco, Inc. Worldwide Headquarters:

3500 Pelco Way, Clovis, California 93612-5699 USA

USA & Canada
International
www.pelco.com

Tel [phone] • FAX [phone]

Tel [phone] • FAX [phone]

speaker; 600-ohm differential; 1 Vp-p
maximum signal level

Pelco, the Pelco logo, Endura, and Spectra are registered trademarks of Pelco, Inc.

All product names and services identified throughout this document are trademarks or registered

trademarks of their respective companies. The absence of a trademark or registered trademar

from this document does not constitute a waiver of intellectual property rights.

Product specifications and availability subject to change without notice.

Spectra III and EnduraView are trademarks of Pelco, Inc.

©Copyright 2009, Pelco, Inc. All rights reserved.