Pelco TS4000, TS6000 User Manual

®

TS1000, TS4000, TS6000 Series

Tamper Switch Kits

Installation/Operation Manual

C498M-A (9/95)

1.0 WARNINGS

Prior to installation and use of this product, the follow­ing WARNINGS should be observed.

1. Installation and servicing should only be done by
Qualified Service Personnel and conform to all
Local codes.

2. Only use replacement parts recommended by
PELCO.

2.0 SCOPE

The information within this manual covers the installa­tion of the TS1000, TS4000 and TS6000 Series Tamper
Switch Kits.

Installation should be in accordance with all applicable
local and national electric codes, utilizing approved
materials only.

Please thoroughly familiarize yourself with the infor­mation in this manual prior to installation and opera­tion.

Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 • USA • www.pelco.com

[phone] or (1-559) 292-1981 • FAX [phone] or (1-559) 292-3827

International Customers: Tel [phone] or FAX [phone]

3.0 DESCRIPTION

4.0 SPECIFICATIONS

The TS Series tamper switch kits are designed for use
in the HS Series of enclosures. The TS1000 is designed
for use in the HS1000 Series, the TS6000 for use in the
HS6000 Series, and the TS4000 is a generic switch kit
for use in many of the high security enclosures as noted
below).

The tamper switch can be used for both “Normally
Open” or “Normally Closed” circuits, and features a
“Pull-Out” plunger that makes disconnection, while
servicing equipment, unnecessary. The plunger also
features an adjustment screw.

3.1 MODELS

TS1000 Tamper switch kit for HS1000.

Has N.O./N.C. contact with mount
bracket.

TS4000 Tamper switch kit for HS1500,

HS2000, HS3000, HS4000,
HS4000TW Series, HS4100BF,
HS4100BH, HS8000 and HS9000.

TS6000 Tamper switch kit for HS6000.

MECHANICAL

Switch: Plunger type with .20" travel 6-32 x

1/2" adjustment screw

Wire leads: 12", #22 gauge

Black — Common
White — Normally Open
Red — Normally Closed
100 V, maximum switching voltage
25 amp, maximum switching
current

Temp. range: -66° to 212°F (18.9° to 100° C)

Impact: Withstands 2-inch diameter steel

ball from 30-inch drop

Shock: 50 G’s at 11 milliseconds

Vibration: 35 G’s at 54-2000 Hz

Bracket: Galvanized steel .047" thick

Double-sided tape for mounting

(Specificaions subject to change
without notice.)

2 PELCO Manual C498M-A (9/95)