INSTALLATION
TIWM & TIPM (Wall Mount & Pole Mount Adapter)
C6646M (9/19)
Important Safety Instructions
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions
5. Only use attachments/accessories specified by the manufacturer.
6. Installation should be done only by qualified personnel and conform to all local codes.
7. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is
designed for indoor use only and it must not be installed where exposed to rain and moisture.
8. Use only installation methods and materials capable of supporting four times the maximum
specified load.
9. Use stainless steel hardware to fasten the mount to outdoor surfaces.
10. To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply
sealant around the bolt holes between the mount and mounting surface.
11. Only use replacement parts recommended by Pelco.
The product and/or manual may bear the following marks:
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present within
this unit.
This symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
Please thoroughly familiarize yourself with the information in this manual prior to installation and
operation.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
C6646M (9/19) 3
TIWM Wall Mount
The TIWM wall mount has been specifically designed for use with the Sarix TI Series cameras.
The TIWM can be installed on a wall or vertical surface, indoors or outdoors, and is capable of supporting
up to 25 kilograms (55 pounds).
The TIWM has an adjustable tilt table that allows manual positioning of the camera.
TIWM
PARTS LIST
The following parts are supplied.
Qty Description
1 Mount, light duty wall
4 Screw, Flat head, M5 x 14 mm long
1 Allen Key, (For pan/tilt adjustment)
USER SUPPLIED PARTS LIST
The following installation parts and tools are needed but not supplied.
Qty Description
1 Sarix TI Series camera
1 3 mm Allen Key or socket
1 Medium duty thread locker or LOCTITE® 243
1 Appropriate water-tight sealant, if installing the product outdoors
Note: The mounting hardware is not provided.
4 C6646M (9/19)
Loading...