Pelco DX3100 User Manual
Product
DX3100
Issue
The Energy Policy Act of 2005 changes the effective dates of Daylight Saving Time (DST) in
the United States, Canada, and selected other locations. Beginning in March 2007, DST in
affected geogr ap hical reg ion s will begi n three we eks earli er (2: 00 A.M. on the sec ond S unda y
in March) and will end one week later (2:00 A.M. on the first Sunday in November) than in
previous years .
This change in the law invalidates the rule-based DST feature available in the DX3100. There
is no method to change the DST rules in the DX3100.
Note: Users in any region affected by the new DST schedule must
this bulletin to ensure their DX3100 complies with the new schedule. Users in regions
not
affected by the DST change should not perform these procedures.
Resolution
Users operating the DX3100 in regions affected by the new DST schedule must disable DST
functionality on their DX3100 and subsequently adjust the system time manually to comply
with the new DST schedule.
Instructions
Users should refer to the DX3100 manual to see instructions on setting the system time
manually.
Note
: When system time is adjusted backward for the fall time change, the DX3100 will not
record for one hour, until the system time has advanced beyond the previously recorded time.
(Example: When user sets system time back from 2:00 A.M. to 1:00 A.M., the DX3100 will
not resume recording until system time is 2:00:01 A.M.). Contact Pelco product support at 1800-289-9100 for details.
The information on this page and the relevant software updates are based on the best available
information at the ti me of p o sting .
perform the procedures in
Loading...