Paxton Net2 User Manual

15/04/2011

Ins-30150 Net2 Caller ID reader

Technical Support

Paxton

01273 811011

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Net2

Caller ID reader

(Optional)

redaeR

[e-mail]

SIM CARD

Power

Antenna

Network

Control Unit

Activity

Connection to a Net2

ACU reader port

LED indications

Power - 12v DC supply OK
Network - Connected to the Mobile phone network
Activity - The reader is receiving data from a mobile phone

Installation

To register the SIM, create an account on the Paxton website. < http://paxton.info/1713 >
The phone number will be supplied within 60 minutes of this process. There is a small monthly charge per SIM for
this service, however, no data charges are incurred as the caller ID is sent without making a full connection.

Insert the SIM card in its holder at the top right of the unit.

A drilling template for the plastic housing is available at < http://paxton.info/1715 >

If the device is to be installed where the mobile signal may be low, the antenna should be installed externally.

Secure the antenna by:

1. Internal - Remove the peel off paper from the adhesive strip and x within the enclosure.

2. Externally - Disconnect the SMA screw connection and route the cable through any of the cabinet push-out plugs

and x to a smooth surface.

Wire the Caller ID reader colour for colour to a Net2 ACU reader port within a maximum cable length of 15 metres.
Belden 9540 is recommended for all data cable wiring.

If a token reader is also tted, it is connected to the Caller ID's own reader port within a maximum cable length to

the Net2 ACU of 100 metres.

Power up the unit and conrm that the Power LED comes on. The Network LED will come on within a few minutes

once the unit is active on its GSM network.

Adding the user's phone to a Net2 user record

Set the reader operating mode in the Net2 software to 'Paxton Reader' and the Operating mode to 'Token only'

Enter the last 8 digits of the phone number into the Net2 user record as the token number.
A phone number of 0777 123 456 becomes 77123456 as a Net2 token.

Specications

Features

Phones supported

Carrier frequency

Electrical

Voltage - Reader module

Current - Reader module

Additional power supply required

Cable length between ACU and Caller ID reader

Environment

Operating temperature

Waterproof

Dimensions

White plastic housing

Min

10V DC 14V DC

- 20 °C + 55 °C

Width

200 mm 200 mm 75 mm

Max

500 mA

15 m

Height

Caller ID enabled

Quad band GSM

No

No

Depth

The declaration of conformity is available on request. Contact details are provided at: http://paxton.info/596

Paxton Access Ltd hereby declares that this product is in conformity with all the essential requirements of Directive

1999/5/EC. This equipment is intended for use in all EU and EFTA countries and all other countries worldwide.